Usage of LDG-25 electromagnetic flowmeter

Description :

　　This product has a simple and reliable structure, no movable parts, and a long working life. No flow blocking components, no pressure loss or fluid blockage.

　　1、 Technical parameters:

　　Caliber: DN10-DN2000 (mm) Special customizable

　　Nominal pressure: 0.6-4.0MPa (differentiated by caliber, special high pressure can be customized)

　　Electrode materials: 316L stainless steel, Hastelloy C, Hastelloy B, titanium, tantalum, platinum iridium electrode

　　Lining materials: polytetrafluoroethylene (PTFE), perfluoroethylene propylene (FEP), chloroprene rubber (Ne), polyurethane rubber (PU)

　　Medium temperature: -40~180 ℃ (limited by the temperature resistance characteristics of the lining material, as follows:

　　Neoprene rubber lining: -40~+80 ℃ Polyurethane rubber lining: -10~+60 ℃

　　PTFE lining: -30~+120 ℃, PTFE lining: -30~+180 ℃

　　Shell material carbon steel (customizable stainless steel shell)

　　Protection levels IP65, IP67, IP68

　　Working power supply 220VAC, 24VDC

　　Current output 4~20mA

　　2、 Characteristics:

　　The measurement of flow rate is not affected by changes in fluid density, viscosity, temperature, pressure, and conductivity. The sensor induced voltage signal is linearly related to the average flow rate, resulting in high measurement accuracy (0.3-0.5%).

　　There is no obstruction in the measuring pipeline, so there is no additional pressure loss, which has significant energy-saving significance.

　　There are no movable parts inside the measuring pipeline, so the sensor has a long lifespan.

　　The straight pipe section required for the sensor is relatively short, making it easy to install.

　　Reasonable selection of electrode and lining materials can resist corrosion and wear.

　　3、 Installation:

　　1. Try to avoid ferromagnetic objects, high radio frequency, strong vibration interference sources, and equipment with strong electromagnetic fields (such as high-power motors, large transformers, etc.) to avoid magnetic fields affecting the working magnetic field and flow signal of the sensor.

　　2. It should be installed in a dry and ventilated place as much as possible, and should not be installed in damp or water prone areas.

　　3. It is advisable to avoid direct sunlight and rain as much as possible, and the ambient temperature should be between -20 and 60 ℃ with a relative humidity of less than 95%.

　　4. Choose a place that is easy to maintain and has convenient activities.

　　5. The flowmeter should be installed at the rear end of the water pump and must not be installed on the suction side.

AfterSalesService :

• Usage of LDG-25 electromagnetic flowmeter