Sales of DN350 electromagnetic flowmeter DN350 electromagnetic flowmeter direct sales

Description :

　　This product is mainly used to measure the volumetric flow rate of conductive liquids and slurries in closed pipelines. Such as water, sewage, mud, pulp, various acids, alkalis, salt solutions, food slurries, etc.

　　1、 Characteristics:

　　There are no obstruction components inside the flowmeter, and there is almost no pressure loss or fluid blockage.

　　No mechanical inertia, fast response, wide fluid measurement range (flow velocity 0.3-12m/s), good stability, can be used for automatic detection, adjustment, and programmable systems.

　　Measuring liquids with conductivity greater than 5u S/cm, the measurement is not affected by changes in fluid density, viscosity, temperature, pressure, and conductivity. The sensor's induced voltage signal is linearly related to the average flow rate, and the measurement accuracy is high.

　　Accuracy levels: 0.2, 0.5, 1.0, 1.5. Can meet the needs of different users.

　　The sensor part only has the inner lining and electrodes in contact with the measured liquid. As long as suitable electrode and inner lining materials are selected, it can be corrosion-resistant and wear-resistant.

　　2、 Technical parameters:

　　Accuracy level: ± 0.5%, ± 1%

　　Lining materials: polyurethane, chloroprene rubber, polytetrafluoroethylene, etc

　　Electrode materials: stainless steel, Hastelloy, titanium, platinum iridium alloy, etc

　　Connection methods: flange clamping, flange connection, etc

　　Medium temperature: 0 ℃~70 ℃, 0 ℃~130 ℃ (0 ℃~180 ℃)

　　Nominal pressure: 1.0Mpa~32 Mpa

　　Protection level: IP65, IP68

　　Explosion proof mark: ExibBT4

　　Working voltage: 220VAC, 24VDC

　　3、 Installation method:

　　1. Vertical installation, the sensor should be inserted into the pipeline at an angle of less than 5 ° to the vertical diameter of the pipeline section, suitable for measuring clean media with low pipeline vibration.

　　2. Tilted installation, with the axis of the sensor at a 45 ° angle to the axis of the measured pipeline, is suitable for measuring the flow rate of liquids with large diameters and other impurities in the measuring medium. This installation method has low water resistance and should not be tangled.

　　3. Clean the welding slag and burrs on the installation base of the tested tube.

　　4. Close the upstream flow control valve or use low-pressure water supply.

　　5. Pay attention to the long cavity of the ball valve facing upwards, check if the ball valve can be fully opened and closed, and install the clamping thread seat, clamping nut, and rubber sealing ring onto the ball valve.

AfterSalesService :

• DN350 electromagnetic flowmeter