Sell DN800 electromagnetic flowmeter DN800 electromagnetic flowmeter direct sales

Description :

　　This product has measurement value power-off protection and air traffic control alarm function. The flow direction of the fluid can be set, so the installation of the sensor is not limited by the direction of liquid flow and can achieve bidirectional flow measurement.

　　1、 Technical parameters:

　　Nominal diameter (mm) (special specifications can be customized)

　　Pipeline type PTFE lining: DN10~DN600

　　Pipeline rubber lining: DN40~DN2200

　　Flow direction: positive, negative, net flow

　　Range ratio: 150:1

　　Repetitive error: ± 0.1% of the measured value

　　Accuracy level: Pipeline type: 0.5 level, 1.0 level

　　Temperature of the tested medium: ordinary rubber lining: -20 to+60 ℃; High temperature rubber lining: -20 to+90 ℃

　　PTFE lining: -30 to+100 ℃; High temperature PTFE lining: -20 to+180 ℃

　　Rated working pressure: (high pressure can be customized) DN10- DN150: ≤ 1.6MPa; DN200－DN350：≤1.0MPa

　　DN400－DN1000：≤0.6MPa； DN450－DN2200：≤0.25MPa

　　Flow velocity range: 0.1-15m/s

　　Conductivity range: The conductivity of the measured fluid is ≥ 5 μ s/cm

　　2、 Product features:

　　1. Suitable for volumetric flow measurement of conductive fluids with conductivity greater than 5 ц s/cm;

　　2. There are no active or obstructed components inside the measuring tube, and the pressure loss is small;

　　3. Lining and electrodes with different materials have good anti-corrosion performance;

　　4. Not affected by medium, density, viscosity, temperature, pressure, and conductivity;

　　5. Low frequency rectangular wave excitation, less susceptible to interference, stable and reliable;

　　6. The converter has low energy consumption, simple and convenient installation, and users do not need to debug.

　　3、 Attention:

　　1. The ambient temperature or the radiation temperature on the surface of the flowmeter converter is greater than 60 ℃.

　　2. In situations where pipeline vibration is significant.

　　3. In situations where the aluminum casing of the converter is severely corroded by corrosive gases.

　　4. In places with high humidity or corrosive gases on site.

　　5. Flow meters are installed in high-altitude or underground environments where debugging is inconvenient.

AfterSalesService :

• DN800 electromagnetic flowmeter