Sell LDG electromagnetic flowmeter LDG-350 electromagnetic flowmeter for direct sales

Description :

　　The main structure of this product consists of a magnetic circuit system, measuring conduit, electrode, housing, lining, and converter. Advantages include: measurement is not affected by changes in fluid density, viscosity, temperature, pressure, and conductivity; There are also advantages such as unobstructed flow components inside the measuring tube, no pressure loss, and high measurement accuracy.

　　1、 Technical parameters:

　　Accuracy level: ± 0.5%, ± 1%

　　Lining materials: polyurethane, chloroprene rubber, polytetrafluoroethylene, etc

　　Electrode materials: stainless steel, Hastelloy, titanium, platinum iridium alloy, etc

　　Connection methods: flange clamping, flange connection, etc

　　Medium temperature: 0 ℃~70 ℃, 0 ℃~130 ℃ (0 ℃~180 ℃)

　　Nominal pressure: 1.0Mpa~32 Mpa

　　Protection level: IP65, IP68

　　Explosion proof mark: ExibBT4

　　Working voltage: 220VAC, 24VDC

　　2、 Attention:

　　1. The ambient temperature or the radiation temperature on the surface of the flowmeter converter is greater than 60 ℃.

　　2. In situations where pipeline vibration is significant.

　　3. In situations where the aluminum casing of the converter is severely corroded by corrosive gases.

　　4. In places with high humidity or corrosive gases on site.

　　5. Flow meters are installed in high-altitude or underground environments where debugging is inconvenient.

　　3、 Characteristics:

　　1. The measurement of flow rate is not affected by changes in density, viscosity, temperature, pressure, and conductivity of the flow rate. The sensor induced voltage signal is linearly related to the average flow rate, resulting in high measurement accuracy

　　2. There is no obstruction in the measuring pipeline, so there is no additional pressure loss. There are no movable parts in the measuring pipeline, so the sensor has a long lifespan

　　3. The straight pipe section required for the sensor is relatively short, making it easy to install

　　4. The sensor part only has the inner lining and electrodes in contact with the measured liquid. As long as the electrode and inner lining materials are selected reasonably, they can resist corrosion and wear

　　5. A bidirectional measurement system that can measure both forward and reverse flow rates.

AfterSalesService :

• LDG electromagnetic flowmeter