Sell LDE electromagnetic flowmeter LDE-40 electromagnetic flowmeter for direct sales

Description :

　　This product can measure various corrosive media such as acids, alkalis, salts, etc; The use of wear-resistant rubber as an inner lining is particularly suitable for measuring liquid-solid two-phase flows such as slurry and cement slurry with solid particles and high wear, as well as various suspended liquids such as fibrous liquids and pulp.

　　1、 Technical parameters:

　　Nominal diameter (mm) (special specifications can be customized)

　　Pipeline type PTFE lining: DN10~DN600

　　Pipeline rubber lining: DN40~DN2200

　　Flow direction: positive, negative, net flow

　　Range ratio: 150:1

　　Repetitive error: ± 0.1% of the measured value

　　Accuracy level: Pipeline type: 0.5 level, 1.0 level

　　Temperature of the tested medium: ordinary rubber lining: -20 to+60 ℃; High temperature rubber lining: -20 to+90 ℃

　　PTFE lining: -30 to+100 ℃; High temperature PTFE lining: -20 to+180 ℃

　　Rated working pressure: (high pressure can be customized) DN10- DN150: ≤ 1.6MPa; DN200－DN350：≤1.0MPa

　　DN400－DN1000：≤0.6MPa； DN450－DN2200：≤0.25MPa

　　Flow velocity range: 0.1-15m/s

　　Conductivity range: The conductivity of the measured fluid is ≥ 5 μ s/cm

　　2、 Characteristics:

　　On site, the range can be modified online according to the actual needs of the user.

　　2. The measurement results are independent of physical parameters such as flow velocity distribution, fluid pressure, temperature, density, viscosity, etc.

　　3. High definition backlit LCD display, fully Chinese menu operation, easy to use, simple to operate, easy to learn and understand.

　　4. It has digital communication signal outputs such as RS485, RS232, Hart, and Modbus.

　　5. It has self checking and self judging functions.

　　6. Hourly total volume recording function, which records the total flow volume in hours and is suitable for time-sharing measurement system.

　　7. There are three integrators inside that can display the forward cumulative amount, reverse cumulative amount, and difference cumulative amount respectively. There is also a non power failure timer inside, which can record 16 power failure times.

　　3、 Installation method:

　　1. Vertical installation, the sensor should be inserted into the pipeline at an angle of less than 5 ° to the vertical diameter of the pipeline section, suitable for measuring clean media with low pipeline vibration.

　　2. Tilted installation, with the axis of the sensor at a 45 ° angle to the axis of the measured pipeline, is suitable for measuring the flow rate of liquids with large diameters and other impurities in the measuring medium. This installation method has low water resistance and should not be tangled.

　　3. Clean the welding slag and burrs on the installation base of the tested tube.

　　4. Close the upstream flow control valve or use low-pressure water supply.

　　5. Pay attention to the long cavity of the ball valve facing upwards, check if the ball valve can be fully opened and closed, and install the clamping thread seat, clamping nut, and rubber sealing ring onto the ball valve.

AfterSalesService :

• LDE electromagnetic flowmeter