Sell LDG electromagnetic flowmeter LDG-1000 electromagnetic flowmeter for direct sales

Description :

　　The main components of this product are: measuring tube, electrode, excitation coil, iron core, and magnetic yoke housing. Mainly used to measure the volumetric flow rate of conductive liquids and slurries in closed pipelines. Such as water, sewage, mud, pulp, various acids, alkalis, salt solutions, food slurries, etc.

　　1、 Characteristics:

　　The measurement of flow rate is not affected by changes in fluid density, viscosity, temperature, pressure, and conductivity. The sensor induced voltage signal is linearly related to the average flow rate, resulting in high measurement accuracy (0.3-0.5%).

　　There is no obstruction in the measuring pipeline, so there is no additional pressure loss, which has significant energy-saving significance.

　　There are no movable parts inside the measuring pipeline, so the sensor has a long lifespan.

　　The straight pipe section required for the sensor is relatively short, making it easy to install.

　　Reasonable selection of electrode and lining materials can resist corrosion and wear.

　　2、 Technical parameters:

　　Accuracy level: ± 0.5%, ± 1%

　　Lining materials: polyurethane, chloroprene rubber, polytetrafluoroethylene, etc

　　Electrode materials: stainless steel, Hastelloy, titanium, platinum iridium alloy, etc

　　Connection methods: flange clamping, flange connection, etc

　　Medium temperature: 0 ℃~70 ℃, 0 ℃~130 ℃ (0 ℃~180 ℃)

　　Nominal pressure: 1.0Mpa~32 Mpa

　　Protection level: IP65, IP68

　　Explosion proof mark: ExibBT4

　　Working voltage: 220VAC, 24VDC

　　3、 Installation:

　　1. Try to avoid ferromagnetic objects, high radio frequency, strong vibration interference sources, and equipment with strong electromagnetic fields (such as high-power motors, large transformers, etc.) to avoid magnetic fields affecting the working magnetic field and flow signal of the sensor.

　　2. It should be installed in a dry and ventilated place as much as possible, and should not be installed in damp or water prone areas.

　　3. It is advisable to avoid direct sunlight and rain as much as possible, and the ambient temperature should be between -20 and 60 ℃ with a relative humidity of less than 95%.

　　4. Choose a place that is easy to maintain and has convenient activities.

　　5. The flowmeter should be installed at the rear end of the water pump and must not be installed on the suction side; The valve should be installed on the downstream side of the flow.

　　6. For liquid-solid two-phase fluids, vertical installation is adopted to ensure uniform wear of the sensor lining and extend its service life.

　　7. When the installation position is not filled with the medium, the method of raising the rear end pipeline of the flow pipe can be adopted to fill the pipe. It is strictly prohibited to install flow meters at pipeline points and water outlets.

AfterSalesService :

• LDG electromagnetic flowmeter