Sell LDE electromagnetic flowmeter LDE-65 electromagnetic flowmeter for direct sales

Description :

　　This product is a fully intelligent flowmeter developed by our company using advanced technology both domestically and internationally. It has the characteristics of high measurement accuracy, high reliability, good stability, and long service life.

　　1、 Structure

　　The product structure mainly consists of magnetic circuit system, measuring conduit, electrode, shell, lining, and converter.

　　2、 Performance indicators

　　Flow velocity measurement range: (0.05-10) m/s

　　Power consumption:<15VA

　　Protection level: IP68

　　Connection method: flange connection

　　Electrode materials: molybdenum containing stainless steel OCr18Ni12Mo2Ti, Hastelloy B, Hastelloy C, titanium Ti, tantalum, etc

　　Measuring pipeline diameter: DN (32-6000) mm

　　Instrument accuracy: Level 1.0

　　Work pressure: ≤ 1.6MPa

　　Medium temperature: 0-80 ℃

　　3、 Application and Characteristics

　　1. Applicable medium: any conductive liquid.

　　2. Not applicable to media: non-conductive liquids, gases, and vapors.

　　3. Negative pressure pipelines cannot be used.

　　4. The measurement is not affected by changes in fluid density, viscosity, temperature, pressure, and conductivity.

　　5. The requirement for a straight pipe section with no obstructed flow components and no pressure loss inside the measuring tube is low. It has unique suitability for measuring slurry.

　　6. There are no movable parts or flow blocking components inside the pipeline, and there is almost no additional pressure loss during measurement.

　　7. It has self checking and self diagnostic functions.

　　8. The range can be modified online according to the actual needs of the user on site.

　　4、 Installation

　　1. Horizontal and vertical installation

　　Sensors can be installed horizontally and vertically, but it should be ensured to avoid the influence of sediment and bubbles on the measuring electrode, and the electrode axis should be kept horizontal. When installed vertically, the fluid should flow from bottom to top. The sensor cannot be installed at the highest position of the pipeline, as this position is prone to the accumulation of air bubbles.

　　2. Ensure full pipe installation

　　Ensure that the flow sensor is filled with the measured fluid in the pipeline during measurement and that there is no non full pipe state. If the pipeline is not full or the outlet is empty, the sensor should be installed on a siphon tube.

　　3. Installation between bends, valves, and pumps

　　To ensure the stability of the measurement, a straight pipe section should be installed in front and behind the sensor, with its length given in the following figure. If it cannot be achieved, a current stabilizer should be used or the cross-sectional area of the measurement point should be reduced.

　　4. Sensors cannot be installed at the inlet of the pump

　　To avoid negative pressure, the sensor should not be installed at the inlet of the pump, but at the outlet of the pump.

AfterSalesService :

• Sell LDE electromagnetic flowmeter