Sell LDE-150 electromagnetic flowmeter

Description :

　　Sell LDE-150 electromagnetic flowmeter

　　This product has a simple and reliable structure, no movable parts, and a long working life. No flow blocking components, no pressure loss or fluid blockage. The measurement accuracy is not affected by the type of measured medium and its physical parameters such as temperature, viscosity, density, pressure, etc.

　　1、 Selection of installation location:

　　1. The flow direction indicator on the sensor must be consistent with the direction of the measured medium flow inside the pipeline.

　　2. The installation position must ensure that the measuring tube is filled with the measured medium.

　　3. Choose a location with smaller fluid flow impulse, which should be away from the pump and local resistance components (valves, elbows, etc.)

　　4. When measuring two-phase fluids, a location that is not prone to phase separation should be selected.

　　5. Installation in areas with negative pressure inside the pipe should be avoided as much as possible.

　　6. When the measured medium easily causes adhesion and scaling on the inner wall of the electrode and measuring tube, it is recommended that the flow velocity inside the measuring tube should not be less than 2m/s.

　　At this point, a tapered pipe slightly smaller than the process diameter can be used. To clean electrodes and measuring tubes without interrupting flow in the process pipeline, sensors can be installed in parallel with cleaning ports.

　　Sell LDE-150 electromagnetic flowmeter

　　2、 Technical parameters:

　　Caliber: DN10-DN2000 (mm) Special customizable

　　Nominal pressure: 0.6-4.0MPa (differentiated by caliber, special high pressure can be customized)

　　Electrode materials: 316L stainless steel, Hastelloy C, Hastelloy B, titanium, tantalum, platinum iridium electrode

　　Lining materials: polytetrafluoroethylene (PTFE), perfluoroethylene propylene (FEP), chloroprene rubber (Ne), polyurethane rubber (PU)

　　Medium temperature: -40~180 ℃ (limited by the temperature resistance characteristics of the lining material, as follows:

　　Neoprene rubber lining: -40~+80 ℃ Polyurethane rubber lining: -10~+60 ℃

　　PTFE lining: -30~+120 ℃, PTFE lining: -30~+180 ℃

　　Shell material carbon steel (customizable stainless steel shell)

　　Protection levels IP65, IP67, IP68

　　Working power supply 220VAC, 24VDC

　　Current output 4~20mA

　　3、 Product features:

　　1. Suitable for volumetric flow measurement of conductive fluids with conductivity greater than 5 ц s/cm;

　　2. There are no active or obstructed components inside the measuring tube, and the pressure loss is small;

　　3. Lining and electrodes with different materials have good anti-corrosion performance;

　　4. Not affected by medium, density, viscosity, temperature, pressure, and conductivity;

　　5. Low frequency rectangular wave excitation, less susceptible to interference, stable and reliable;

　　6. The converter has low energy consumption, simple and convenient installation, and users do not need to debug.

AfterSalesService :

• LDE electromagnetic flowmeter