Jiangsu LUGB-150 Vortex Flow Meter

Description :

　　Jiangsu LUGB-150 Vortex Flow Meter

　　1. Overview:

　　The vortex flowmeter belongs to the velocity flowmeter, developed based on the Karman vortex principle, and can be widely used to measure the volume flow rate and mass flow rate of liquids, gases, and steam (saturated steam, superheated steam). Widely used in industries such as petroleum, chemical, light industry, power heating, environmental protection, municipal, and electricity.

　　2、 Unique features:

　　1. Steam, gas, and liquid can all be measured;

　　2. Low pressure loss;

　　3. No compensation is required when measuring volumetric flow rate;

　　4. Components with simple structure and no motion wear and tear;

　　5. High precision, high reliability, no need for on-site debugging;

　　6. Easy to install and maintain;

　　7. It can transmit traffic signals over long distances, connect with computers, and achieve integrated management.

　　Jiangsu LUGB-150 Vortex Flow Meter

　　3、 Technical indicators:

　　1. Measuring fluids: saturated steam, superheated steam, compressed air, general gases, liquids, etc

　　2. Rated pressure: 1.6Mpa, 2.5Mpa, 4.0Mpa and above

　　3. Body material: 304 stainless steel

　　4. Output signals: pulse signal, current signal, RS485

　　5. Electrical interface: M20 * 1.5

　　6. Environmental temperature: -20-60 degrees Celsius

　　7. Fluid temperature: -20-350 degrees Celsius

　　8. Accuracy level: liquid level 0.5, gas level 1.5

　　9. Power supply: 12-24VDC

　　4、 Installation method:

　　1. The installation position should be selected as much as possible in a location without pipeline vibration or with low vibration, and the vibration acceleration should not exceed 2g. If the vibration is large, vibration reduction measures need to be taken;

　　2. There must be sufficient straight pipe sections upstream and downstream of the sensor;

　　3. The maintenance valve is installed upstream of the sensor, and the flow control valve is installed downstream of the sensor;

　　4. Try to choose a location that is easy to install and maintain;

　　5. Choose a location with a dry environment;

　　6. Sensors can be installed on horizontal or vertical pipelines. But when installed on a vertical pipeline, the medium must flow from bottom to top.

　　7. Sensors should be installed indoors as much as possible, and attention should be paid to waterproofing when installed outdoors. Cables outside the amplifier should be bent into a U-shape.

AfterSalesService :

• LUGB Vortex Flow Meter