Anti corrosion DN32 electromagnetic flowmeter

Description :

　　Anti corrosion DN32 electromagnetic flowmeter

　　This product can output standard current signals for recording, adjusting, and controlling purposes while conducting on-site monitoring and display, achieving automatic detection control and long-distance signal transmission.

　　1、 Characteristics:

　　1. Impurities and fibers do not affect the measurement

　　2. Body lining: Two types of corrosion-resistant linings, polytetrafluoroethylene and polyurethane

　　3. Antibacterial and anti stick electrode

　　4. Positive and negative cumulative flow

　　5. Intelligent self diagnostic function, comprehensively solving your worries

　　Anti corrosion DN32 electromagnetic flowmeter

　　2、 Technical parameters:

　　Nominal diameter (mm) (special specifications can be customized)

　　Pipeline type PTFE lining: DN10~DN600

　　Pipeline rubber lining: DN40~DN2200

　　Flow direction: positive, negative, net flow

　　Range ratio: 150:1

　　Repetitive error: ± 0.1% of the measured value

　　Accuracy level: Pipeline type: 0.5 level, 1.0 level

　　Temperature of the tested medium: ordinary rubber lining: -20 to+60 ℃; High temperature rubber lining: -20 to+90 ℃

　　PTFE lining: -30 to+100 ℃; High temperature PTFE lining: -20 to+180 ℃

　　Rated working pressure: (high pressure can be customized) DN10- DN150: ≤ 1.6MPa; DN200－DN350：≤1.0MPa

　　DN400－DN1000：≤0.6MPa； DN450－DN2200：≤0.25MPa

　　Flow velocity range: 0.1-15m/s

　　Conductivity range: The conductivity of the measured fluid is ≥ 5 μ s/cm

　　Anti corrosion DN32 electromagnetic flowmeter

　　3、 Installation:

　　This product can measure various corrosive liquids such as acids, alkalis, salts, etc; Various flammable and explosive media; Various industrial wastewater, pulp, mud, etc. Electromagnetic flow meters cannot be used to measure gases, vapors, and liquids containing large amounts of gas. Cannot be used to measure liquid media with low conductivity, and cannot measure high-temperature and high-pressure fluids.

　　Integrated type: Under favorable on-site and environmental conditions, an integrated type is generally chosen, which means that the sensor and converter are assembled into one unit.

　　Separated type: The sensor and converter are installed separately in different locations, and the separated type is generally selected when the following situations occur.

　　(1) The ambient temperature or the radiation temperature on the surface of the flowmeter converter exceeds 60 ℃.

　　(2) In situations where pipeline vibration is significant.

　　(3) In situations where the aluminum casing of the sensor is severely corroded.

　　(4) In places with high humidity or corrosive gases on site.

　　(5) Flow meters are installed in places where high-altitude or underground debugging is inconvenient.

AfterSalesService :

• DN32 electromagnetic flowmeter