FQW20-90/K pneumatic submersible pump blade type high lift mining pneumatic water pump FQW15-30/W

Description :

　　FQW20-90/KPneumatic submersible pump blade type high lift mining pneumatic water pump FQW15-30/W

　　ifFQW20-90/K Pneumatic Submersible PumpIts potential has been fully realized, and even the Pacific Ocean cannot stop its charm,FQW20-90/K Pneumatic Submersible PumpThe head is high, but it doesn't have to be as high as it needs to be. After all, our mine doesn't have to be as deep as it needs to be. Another important reason is that the power of compressed air is limited, and it cannot be as powerful as an electric motor.

　　FQW20-90/KPneumatic submersible pumpThe overall structure is simple, the appearance is beautiful, the volume is small, and the weight is light. It is easy to move, disassemble, and maintain; The water pump runs smoothly, has a large flow rate, and has a high actual head; There is no clearance between the impeller and the pump body, and the drainage and sewage capacity is strong; It starts and stops quickly, and has overload protection function, so it will not malfunction due to overload. The FQW15-30/W pneumatic submersible pump is not limited by power supply, humidity, dust and other conditions, especially in explosive, flammable, vibration, high temperature and harsh working conditions, it has irreplaceable safety and reliability compared to electric submersible pumps.

　　FQW20-90/KPneumatic submersible pumpUsing Jue on work surfaces and other occasions containing gas and coal dust is safe and reliable. Mainly suitable for mining development, excavation of tunnels, vertical shafts, chemical, oil tanker, shipbuilding and other flammable, explosive and harsh working conditions on site, with compressed air powered construction drainage operations.

　　FQW20-90/KPneumatic submersible pumpHigh head, let's first take a look at its head and other parameters:

　　Model: FQW20-90

　　Lift m: 90

　　Flow rate m3/h: 17

　　Gas consumption m3/min: 4-6

　　Use air pressure mpa: 0.4-0.7

　　Noise db:<<; seventy-five

　　Weight kg: 35

　　FQW20-90/KPneumatic submersible pumpUsage and maintenance

　　1. If the gas supply pressure is greater than 3.5KG/CM2, it can work, but the air pressure must not exceed 8KG/CM2.

　　2. When the water depth exceeds a certain height, a 60mm inner diameter rubber hose should be connected to the exhaust outlet to divert the remaining air out of the water surface for discharge. Water and other impurities should be prevented from entering the exhaust pipe.

　　3. Pay attention to the cleanliness of the air source to prevent debris and dirt from entering the air duct of QYQ17-90 pneumatic submersible pump. During the operation of the FQW15-30/W pneumatic submersible pump, attention should be paid to removing sediment, coal slag, and debris accumulated outside the pump seat to avoid reducing the efficiency of the pump.

　　4. When in use, connect the 25mm inner diameter air inlet cloth rubber tube, and the working pressure should not be lower than 0.3 megapascals. Test run on the ground for three minutes to check whether the startup is flexible and normal. After turning off the air, connect the 38mm inner diameter water pipe at the outlet and put it into the water to open the air and drain.

　　There is no formula to calculate intrinsic value, you must understand itFQW20-90/K Pneumatic Submersible PumpIf you can discover during useFQW20-90/K Pneumatic Submersible PumpWith three advantages of high head, you will be very wealthy. If the company's performance and management personnel are both good, then the quotation is not so important.

AfterSalesService :

• Pneumatic submersible pump