MQT-130/3.0 Pneumatic Anchor Rod Drilling Machine for Coal Mines Easy to Operate Hongyi MQT-130/3.2 Drilling Machine
Category:
mechanical equipment/Fishery machinery and equipment/Mining drilling rig
Model:
MQT-130/3.0
Brand:
Hongyi
Retail Price
2,820.00USD
重量
kg
- Product Description
-
Description :
MQT-130/3.0Pneumatic anchor drilling rig for coal mines, MQT-130/3.2 anchor drilling rig, model of pneumatic anchor drilling rig
MQT-130/3.0Pneumatic anchor drilling rig for coal minesEntering the realm of quality, bringingMQT-130/3.0 Pneumatic Anchor Rod Drilling Machine for Coal MinesBusiness opportunities and product quality are the wings of expansion, soMQT-130/3.2 Anchor Drilling MachinePlease rest assured to purchase, from production to shipment in one line. Welcome to inquire by phone.
MQT-130/3.0Pneumatic anchor drilling rig for coal minesScope of application:
MQT-130/3.0Pneumatic anchor drilling rig for coal minesWidely applicable to tunnels with rock hardness ≤ f10, especially suitable for anchor bolt support operations in coal tunnels. It can drill roof anchor bolt holes and anchor bolt holes, as well as mix and install resin coated anchor bolts and anchors. No other equipment is required to achieve one-time installation and tightening of anchor bolts and nuts, meeting the requirements of initial anchor pre tightening force.
MQT-130/3.0Pneumatic anchor drilling rig for coal minesFeatures:
Mostly made of engineering plastic materials, lightweight and easy to operate.
Using a large-sized motor as power, the power to weight ratio is higher and the service life is longer.
The new type of water valve using technology can adapt to the static pressure water on the surface of coal mines.
Parameter matching is more reasonable, and the drilling rig achieves the maximum output power near the optimal drilling speed.
The propulsion part adopts a new type of fiberglass cylinder, which is safe, explosion-proof, lightweight and flexible.
MQT-130/3.0Pneumatic anchor drilling rig for coal minesparameters
Working pressure Mpa 0.4-0.63
Rated air pressure Mpa 0.5
Rated speed r/min 206
Rated torque N.m 130
Stall torque N.m 220
No load speed r-min ≥ 560
Gas consumption m3 min 4.5
*High thrust KN 8
Flushing water pressure Mpa 0.6-1.2
MQT-130/3.0Pneumatic anchor drilling rig for coal minesInstallation and Debugging:
Install anchor rods after drilling. Pull the drill rod out of the drill rod joint and insert it into the double hexagonal sleeve.
Remove the nut from the anchor rod and insert it into the gasket, then tighten the nut again and use an anchor drill to tighten the nut. If the torque cannot meet the requirements, the nut can be tightened by pushing the control arm counterclockwise with your hand.
3. Twist the nut onto the anchor rod and insert it into the double hexagonal sleeve. Use an anchor drilling rig to send the anchor rod and the medicine package to the bottom of the hole (with the resin medicine package at the top). After the anchor rod rotates rapidly for a few seconds, stop rotating and continue to maintain the thrust until the medicine package solidifies, causing the machine to fall down.
AfterSalesService :
Key words:- Pneumatic anchor drilling rig for coal mines
More Products
