Supply LKJ-42 hydraulic ring chain shears with flexible use LKJ-50 hydraulic ring chain shears in stock

Description :

　　LKJ-42Ring chain hydraulic shear, LKJ-50 hydraulic ring chain cutter, mining ring chain hydraulic shear

　　LKJ-42Loop chain hydraulic shearReputation comes from quality, quality comes from quality, we doLKJ-42 ring chain hydraulic shearSelf improvement, healthy competition, mutual appreciation and support,LKJ-50 Hydraulic Circular Chain ClipperStep forward every day and embark on the path of success.

　　LKJ-42Loop chain hydraulic shearProduct Introduction

　　The products produced by our companyLKJ-50 Hydraulic Circular Chain ClipperMainly used for cutting anchor chains (circular chains) in various industrial and mining, metallurgical, petroleum, bridge, fire protection and other departments. This machine adopts a split type structure, which has the advantages of small size, light weight, easy operation, flexible use, and high cutting force. Especially, the manual anchor chain (circular chain) cutter does not require a power supply, making it more suitable for field operations.

　　LKJ-42Loop chain hydraulic shearMain technical performance parameters

　　Cut off object: circular chain chain below Φ 42

　　ZUI high work pressure: 70 (Mpa)

　　Blade opening: 50 (mm)

　　ZUI large cutting force: 1400 (kN)

　　Working stroke of the knife: 45 (mm)

　　Length: 275 × 305 × 545 (mm)

　　Weight: 102 (kg)

　　LKJ-42Loop chain hydraulic shearUsage and precautions

　　1LKJ-50 Hydraulic Circular Chain ClipperUsed for cutting metal materials of circular chains with a diameter of 26-42mm. Adjust the bolt according to the diameter of the circular chain during use, and place the anchor chain circular chain at a right angle to the blade

　　2. Check the oil level: If the oil level is insufficient, the performance of the machine cannot be fully utilized. Some abnormal situations such as poor performance of major movements are caused by insufficient fuel.

　　3. Use 32 # anti-wear hydraulic oil or 10 # transformer oil in the oil cylinder. When refueling, you can remove the rubber protective sleeve at the end of the oil pump, and then unscrew the 8mm hex socket screw to add oil to the oil outlet pipe. However, refueling should be done slowly and the handle should be shaken to exhaust the air. The oil pipe should no longer emit bubbles and should be filled up immediately

　　four LKJ-50Hydraulic circular chain cutterAfter cutting, there should be no material heads left between the blades of the knife holder. Otherwise, the cutting head will be obstructed and the machine body will be damaged.

　　5. Calculate the cutting force of harder and tougher steel, and pay attention to the risk of short material flying out and injuring people, and take safety measures.

　　six LKJ-42Loop chain hydraulic shearWhen using, first fill the manual pump with 32 # anti-wear hydraulic oil, then connect the quick connector of the manual pump to the main oil cylinder, and tighten the oil drain screw on the oil pump to start working. Similarly, when the work is completed, loosen the oil drain screw and the working oil cylinder will automatically retract

　　seven LKJ-50Hydraulic circular chain cutterBefore use, empty back a few working trips and wait for each part to move flexibly without any oil leakage before use.

　　eight LKJ-42Loop chain hydraulic shearIf there is a phenomenon of empty tapping during use, you can first loosen the oil drain screw on the pump body, lift the pump body vertically and tap it downwards a few times, then tighten the oil drain screw, and continue to use

　　When there is a load, do not remove the quick connector to avoid accidents and damage to the components

AfterSalesService :

• Loop chain hydraulic shear