MODEL100 online dust concentration sensor bag dust collector leak detector

Description :

　　1MODEL100Overview of bag dust collector leak detector:

　　The MODEL100 bag filter leak detector measures the electrostatic induction of dust particles passing through a fixed probe. Dust particles and probes induce static charges, which are amplified by the probe and transmitted to the monitoring and control system. The size of static charge is proportional to the flow rate of dust particles. The high-tech electronic circuit of the MODEL100 bag dust collector leak detector converts this part of the charge into a control signal output, triggering the alarm for excessive dust emissions, and continuously recording the total amount or concentration of dust particles. This device provides the latest communication coupling technology in the world. This is a modern, accurate, and stable monitoring technology, particularly suitable for continuous emission recording and data accumulation. The working principle of this monitoring system is to use the charge induction generated by the flow of dust particles around the probe to confirm the online emission amount (mg/sec) or emission concentration (mg/m3) of dust particles. In the case of relatively stable combustion conditions (i.e., at the same emission point, there is no significant change in flow rate, temperature, pressure, humidity, and smoke particle properties, with a variation of less than ± 90%), the MODEL100 bag filter leak detector can also be used for online monitoring of emission concentration (unit=mg/M3) after direct calibration.

　　IIMODEL100Technical parameters of bag dust collector leak detector:

　　Operating environment temperature: -20 ℃~60 ℃ (electronic components);

　　Operating environment humidity: 90% without condensation;

　　Operating environment vibration: continuous oscillation, any direction, any frequency: root mean square value 2g (20m/s2);

　　Operating environment electromagnetic field: can reach a value of=60 A/m at 50 Hz (equivalent to a magnetic field of 50 AT in a 1 meter x 1 meter square electromagnetic coil);

　　Operating environment protection: Protection level: IP66/NEMA4 aluminum alloy shell, suitable for installation in non corrosive environments, stainless steel probe;

　　Pipeline gas pressure: -0.1~1MPa;

　　Pipeline gas flow velocity: 1m/s to 30m/s;

　　Pipeline gas temperature: -50 ℃~450 ℃;

　　Outer diameter of pipeline: 0.1 meters to 4 meters;

　　Probe structure: The standard probe is M6, with a length of 160 mm and a 316 stainless steel rod;

　　Dust particle size range: 0.1 μ M to 200 μ M, can still be received outside the nominal range, but the signal characteristics are slightly different;

　　Zero drift: (time) less than 1% of the range per year;

　　Within the temperature range, below 1% of the measuring range;

　　Full range drift: (time) less than 1% of the range per year;

　　Within the temperature range, below 1% of the measuring range;

　　Line stability: All components of the system are made of high stability electronic assemblies;

　　Noise resistance: All 50 or 60 Hz audio and harmonics are filtered out before the signal is received;

　　Measurement range: 0-9/12/25/50/100/200/400/800/1000 mg/M3;

　　Transmitter output mode: two-wire 4-20mA (built-in isolator, explosion-proof and anti-interference);

　　Transmitter power supply: 15V-32VDC.

　　About Jingcheng

AfterSalesService :

• Bag dust collector leak detector