Sample Concentrator Digital Display Temperature Control Portable Low Noise Bioanalyzer, Laboratory 12 Hole Concentrator

Description :

　　Sample concentrator, water bath sample concentrator, extractor, dry nitrogen blower, water bath nitrogen blower

　　1、 Product Introduction:

　　This product comes with an air source. Stainless steel is used as the air chamber, which is exquisitely made, compact in size, and easy to carry. It is equipped with a digital temperature control instrument, which has the characteristics of uniform heating temperature, low noise, large air output, and rapid concentration of samples in a short time. It is suitable for rapid concentration of samples in the environment.

　　Its application areas:

　　1. Pesticide analysis: vegetables, fruits, grains, plant tissues, etc

　　2. Pharmaceutical drug testing: Traditional Chinese medicine pharmaceuticals and drug testing

　　3. Environmental analysis: drinking water, groundwater, polluted water, etc

　　4. Bioanalysis: Serum, plasma, blood, urine

　　5. Product inspection: Testing for dioxins, Croats, etc

　　6. Food and beverages: milk, alcohol, liquid beverages

　　2、 Product parameters:

　　1. Heating hole: 12 holes

　　2. Hole depth: 56mm

　　3. Air source: Air source

　　4. Diameter: 16.5mm

　　5. Temperature error: ≤± 0.5 ℃

　　6. Flow rate: 0-25L/min

　　7. Safety: Intrinsically safe for organic solvents

　　8. Power: 200W

　　9. Heating range: Room temperature -100 ℃

　　3、 Usage steps:

　　1. Open the portable suitcase, check if the instrument is intact, and connect the power supply.

　　2. Adjust the height of the bracket so as not to connect uranium to the sample level (1cm).

　　3. Set the temperature according to the electronic component manual, and then turn on the heating switch (red key).

　　4. After the temperature reaches the set temperature, remove the bracket and place the test tube containing the concentrated solution into the sample chamber. Adjust the position of the blower tube to be about 1cm above the liquid level of the test tube.

　　5. Turn on the air source switch and press the blow button (green key).

　　After the sample concentration is completed, turn off the heating switch and the blowing switch in sequence, and remove the test tube.

　　7. After the temperature in the sample room drops to room temperature, restore the instrument to its operational state.

AfterSalesService :

• Sample Concentrator