Hainan Haikou Chlorinated Rubber Paint Weather resistant, Acid alkali resistant, Moisture resistant, Anti corrosion Paint Chlorinated Rubber Coating

Description :

　　Chlorinated rubber primer is designed for spray painting applications, including steel protection coatings for moderate to harsh environments, interior wall and ceiling protection coatings, with antibacterial properties and partial chemical resistance Can be coated at low temperatures.

　　Technical Specifications

　　Solid content: ≥ 40% Dry film thickness: 35 microns Theoretical coating rate: 9 square meters/kg Mixing ratio: Single component Drying time: Surface drying for 2 hours Hard drying for 24 hours (substrate temperature 5 ℃) Surface drying for 1 hour Hard drying for 8 hours (substrate temperature 25 ℃) Surface drying for 0.5 hours Hard drying for 8 hours (substrate temperature 35 ℃) Coating interval: Short time for 8 hours Long time for 7 days (substrate temperature 5 ℃) Short time for 4 hours Long time for 7 days (substrate temperature 5 ℃) Short time for 2 hours Long time for 7 days (substrate temperature 5 ℃) Flash point: ≥ 23 ℃ Specific gravity: Approximately 1.3 kg/liter

　　1. Take effective measures to prevent direct contact between skin and eyes and paint (such as using work clothes, gloves, goggles, face shields, and applying protective oil). If the skin accidentally comes into contact with the product, please rinse thoroughly with water, soap, or appropriate industrial cleaning agents; If the eyes are contaminated, rinse immediately with clean water for at least 10 minutes and seek medical attention immediately. 2. During construction, it is recommended to wear a face mask to avoid inhaling paint mist and harmful gases, especially in poorly ventilated environments. Please handle waste paint buckets carefully to avoid polluting the environment. 3. Paint is flammable and contains volatile flammable solvents, so it must be kept away from sparks and open flames. 4. Smoking is strictly prohibited in the workplace, and effective measures should be taken to prevent the generation of sparks (such as using explosion-proof electrical equipment, eliminating static electricity accumulation, avoiding metal impact, etc.). 5. The construction site should maintain good ventilation as much as possible. To eliminate the risk of explosion during use, sufficient ventilation should be ensured to maintain a gas/air ratio not exceeding 10% of the explosion limit. Typically, 200 cubic meters of ventilation are required per kilogram of solvent (depending on the type of solvent) to maintain this

AfterSalesService :

• Chlorinated rubber primer