Manufacturer provides customized catalytic combustion for Xiamen

Description :

　　Catalytic combustion is a purification method that uses catalysts to oxidize and decompose combustible substances in exhaust gas at lower temperatures. So, catalytic combustion is also known as catalytic chemical conversion. Due to the acceleration of the oxidation decomposition process by the catalyst, most hydrocarbons can be completely oxidized by the catalyst at temperatures of 300-450 ℃.

　　Compared with the thermal combustion method, catalytic combustion requires less auxiliary fuel, consumes less energy, and has smaller equipment and facilities. However, the promotion and application of this method in industrial production processes have been affected by issues such as catalyst poisoning, replacement of catalytic beds, and high cleaning costs.

　　Product performance characteristics:

　　1、 Easy to operate, with automatic control and reliability during device operation.

　　2、 The device starts up and takes 15 to 30 minutes to heat up to the ignition temperature, with energy consumption from the fan power. It automatically compensates when the concentration is low.

　　3、 The honeycomb ceramic carrier catalyst impregnated with advanced precious metals palladium and platinum has a large specific surface area, low resistance, and high purification rate.

　　4、 The waste heat can be returned to the drying oven, reducing the power consumption in the original drying oven, and can also be used as a heat source for other purposes. 5、 Long service life, catalysts are usually replaced every two years, and the carrier is renewable. 6、 Not producing secondary pollutants such as nitrogen oxides (NOX): 7. High performance, purification efficiency of over 99%; 8. Heat recovery rate, heat recovery efficiency ≥ 95%.

　　Nine occupies a small area: 70% to 80% of similar products in the same industry, and there are no special requirements for equipment foundation.

　　The packing layer in the spray tower serves as a mass transfer device for gas-liquid two-phase contact components. The bottom of the packing tower is equipped with a packing support plate, and the packing is placed on the support plate in a disorderly manner. A packing pressure plate is installed above the packing to prevent it from being blown by the rising airflow. The spray liquid of the spray tower is sprayed onto the packing from the top of the tower through the liquid distributor, and flows down along the surface of the packing. The gas is sent from the bottom of the tower, distributed by the gas distribution device, and continuously passes through the gaps of the packing layer in reverse flow with the liquid. On the surface of the packing layer, the gas-liquid phase is in close contact for mass transfer. When the liquid flows down along the packing layer, wall flow phenomenon sometimes occurs, and the wall flow effect causes uneven distribution of gas-liquid phase in the packing layer, thereby reducing mass transfer efficiency. Therefore, the packing layer inside the spray tower is divided into two sections, with a redistribution device installed in the middle. After redistribution, it is sprayed onto the lower packing layer.

AfterSalesService :

• Catalytic combustion equipment