Manufacturer supplies dust bag filter Quanzhou bag dust removal equipment quality

Description :

　　environmental protection measures

　　(1) Appropriate masks and gas masks must be worn during work, and good ventilation measures must be taken.

　　(2) The parts with high solvent evaporation must be equipped with gas collection devices to prevent the diffusion of toxic gases.

　　Product Maintenance

　　Regularly check the operation of control valves, pulse valves, and timers.

　　The failure of the pulse valve rubber diaphragm is a common fault in bag filters, which directly affects the dust cleaning effect. This device belongs to the external filter type, with a skeleton inside the bag. It is necessary to check whether the parts that fix the filter bag are loose and whether the tension of the filter bag is appropriate. Is the support frame smooth to prevent wear and tear on the filter bag. Compressed air is used for dust removal. Therefore, it is required to remove oil mist and water droplets, and the oil-water separator must be cleaned regularly to prevent malfunction of the moving mechanism and blockage of the filter bag.

　　Whether the air volume and pressure and temperature at each testing point are consistent with the design.

　　The installation status of the 3 filter bags, whether there are any occurrences of bag dropping, loosening, wear, etc. after use, can be judged by visually observing the emissions of the chimney after operation.

　　4. Prevent condensation

　　During use, it is necessary to prevent the gas from cooling below the dew point in the bag chamber, especially when using a bag filter under negative pressure. Due to the frequent leakage of air into the outer shell, the gas temperature in the bag chamber is lower than the dew point, causing the filter bag to become damp. This results in dust not being loose but sticking to the filter bag, blocking the fabric holes and causing dust removal failure. This leads to excessive pressure drop in the dust collector, making it unable to continue operating, and some bags may become stuck and unable to remove dust.

　　To prevent condensation, it is necessary to maintain the temperature of the gas in the dust collector and its system at 25-35 ℃ above its dew point (such as the dew point temperature of 58 ℃ for kiln mill integrated machines, and the operating temperature should be above 90 ℃), in order to ensure the good use effect of the filter bag.

　　The bag type composite dust collector utilizes the shell and ash storage system of the original electrostatic precipitator, retains the front stage electric field of the electrostatic precipitator, removes the rear stage electric field, and installs the bag type dust collector in the removed rear stage electric field. By organically combining two types of dust collectors and fully leveraging their respective advantages, the goal of high efficiency, moderate resistance, and extended filter bag life can be achieved.

　　Usually, the dust collection efficiency of an electric field is between 80% and 90%. The remaining 10% to 20% of fine dust flows with the flue gas through the outlet of the electric field and the porous plate of the bag filter. A part of the flue gas enters the bag filter horizontally, while another part of the flue gas flows horizontally and bends towards the lower part of the filter bag, then moves from bottom to top and enters the bag filter. The advantage of this type of horizontal and vertical smoke entering the bag dust collection area at the same time is to ensure a reasonable upward speed in the bag area. The dusty smoke passes through the outer surface of the bag, and the dust is trapped outside the filter bag. Clean gas flows out from the inner cavity of the bag, enters the upper purification chamber, and then merges into the exhaust duct, flows through the outlet horn, pipeline, and fan, and is discharged from the chimney. Among them, the pre dust removal and charging effects of the primary dust removal electric field play an important role in improving the performance of the electric bag composite dust collector.

AfterSalesService :

• bag filter