The manufacturer manufactures and wholesales mobile electric control fire monitors foam water dual-use fire monitors

Description :

　　1、 Installation and commissioning of fixed fire monitors

　　1. After unpacking the fixed fire monitor, please remove one pressure gauge sealed in the monitor base, first puncture the upper rubber of the pressure gauge, and then install it on the rotating body.

　　2. Installation method: First, connect the ball valve to the socket, and then connect the ball valve gun base. (It can also be assembled and used with quick opening self releasing gun seats, fire hydrants, etc.).

　　3. Adjustment method for traffic: Use your thumb to press down on the 5 "traffic pointers" (away from the bottom of the slot), hold the 15 "dual handles" of the cannon head with both hands and rotate them to the desired traffic position. Release your thumb to let the 5 "traffic pointers" fall into the slot, and the adjustment is complete; If the user has no special requirements, the flow rate is set at 50L/S when leaving the factory. The 14 positioning sleeve with fixed part number 5 "flow pointer" has been adjusted and fixed before leaving the factory. Please do not disassemble it without authorization.

　　2、 Operation and use of fixed fire monitors

　　1. Tilt operation: First, release the "tightening handwheel" 2, hold the "gun handle" 1, and move it up and down; Alternatively, the adjusted usage angle can be tightened with a "tightening handwheel" and fixed for use.

　　2. Horizontal rotation operation: First, loosen the 10 "butterfly lock nut", hold the 1 "gun handle", and use it for 360 degree rotation. It can also be rotated to tighten the 10 "butterfly lock nut" at the desired position for fixed use.

　　3. If the spray pressure is found to be too high (gauge pressure of the gun) or the range changes to be closer during use, it is necessary to promptly check whether there are foreign objects blocking the gun head; The cleaning method is as follows: press down the 5 "flow pointer" with your thumb (away from the bottom of the slot), face the gun head, hold the 15 "dual handles" of the gun head with both hands, rotate counterclockwise by about 70 degrees to remove the gun head, and assemble and reset after cleaning. The relative position between the "flow pointer" and the cannon head has been adjusted before leaving the factory. Please do not change it without authorization.

　　3、 Maintenance and upkeep of fixed fire monitors

　　1. There is a circle of 34 steel balls between the gun base and the gun body, which serve as a fixed and horizontal axis for rotation. Butter (lithium based lubricating oil) should be regularly injected from the "straight through oil injection cup" mouth; If 10 "butterfly lock nuts" are found missing or steel balls fall out, they should be promptly replenished and repaired. It is strictly prohibited to use them before repair to avoid accidents.

　　2. Fixed fire monitor components should be kept intact. If loose or damaged fasteners are found, they should be repaired in a timely manner. Lubricating oil should be regularly added to all operating parts.

　　3. If a fixed fire monitor is installed outdoors in a windy and sandy area, please purchase a gun cover or tarpaulin to cover it, in order to prevent blockage of the gun barrel and operational failure.

AfterSalesService :

• fire monitor