Pingxiang Qunxing PTFE Ball Ring

Description :

　　one）Product Description:

　　Produced by the companyPlastic, well shaped, PPS, PPH Ball RingPolypropylene Ball Ring Filler is a new type of filler that has been improved to address some of the main drawbacks of Raschig rings. It involves opening eight layers of rectangular small windows on the wall of a regular Raschig ring, with the window blades overlapping at the center of the ring and the upper and lower window positions overlapping each other. There are rice shaped, cross shaped, cross shaped, etc;

　　two）Product Performance Introduction:

　　Produced by the companyPlastic, well shaped, PPS, PPH Ball RingThe temperature resistance of polypropylene ball ring filler is closely related to its material. The temperature resistance of different plastic materials varies. The instantaneous temperature resistance of polypropylene ball ring is generally above 100 degrees, but should not exceed 110 degrees. But the longest service life is around 70 degrees Celsius at room temperature;

　　3)Product Technical Parameters:

　　4)Product Application:

　　(1) Strong mass and heat transfer capabilities. The temperature difference between the air exiting the air cooling tower and the cold water entering the tower from the upper section can be less than 1 ℃, and a negative temperature difference of 4-5 ℃ can be generated between the outlet temperature of the water cooling tower and the temperature of the incoming sewage nitrogen;

　　(2) Due to the accumulation porosity reaching 94-95%, it is not easy to block and select as foam carrier, which is conducive to variable operating conditions. After increasing the air volume, it is not easy to carry water;

　　(3) Low pressure drop, with a resistance of approximately 10mm water column per meter of packing material;

　　(4) The water consumption of the air cooling tower can be reduced by 30%;

　　(5) Can reduce the cooling capacity of the chiller. In winter, it is not necessary to turn on the machine, and in summer, the cooling capacity can be reduced by 80%, making it possible to achieve an air pre cooling system without a chiller;

　　(6) Easy installation and low manufacturing cost;

　　(7) The relatively low density (0.9kg/m3) results in a lightweight final product.

　　Polypropylene is a flammable substance that can be used at temperatures between 10 and 120 ℃, and will become brittle below 0 ℃. Its structure has greater chemical stability and can withstand most acids, salts, and many organic solutions, but cannot withstand high concentrations of strong acids.

　　Polypropylene is divided into two types: ordinary (use temperature+80 ℃) and enhanced (use temperature+120>℃). Ordinary polypropylene ball ring packing can be used for water-cooled towers; When starting the air cooling tower, if the air compressor is not equipped with a terminal cooler, the air temperature at the time of starting is about 90 ℃. Therefore, reinforced Bao'er ring packing or most ordinary polypropylene Bao'er ring packing should be selected. Stainless steel Bao'er ring packing should be selected at a height of about 2 meters in the bottom layer of the packing to prevent the thermal deformation and compressive strength reduction of the polypropylene Bao'er ring packing.

　　Plastic, well shaped, PPS, PPH fillersPackaging method: woven bag;

　　Plastic, well shaped, PPS, PPH fillersTransportation method: truck transportation;

　　Material: PP/PVC/CPVC/PVDF/PTFE, etc;

　　Material: 304/304L/316/316L/duplex steel/titanium, etc;

AfterSalesService :

• Polytetrafluoroethylene Ball Ring