BK-4B-500KG hook weighing sensor BK-4B tension and pressure sensor
Category:
electron/Sensors, sensitive components/force sensor
Model:
BK-4B-500KG
Brand:
ALLEGRO
Retail Price
180.00USD
重量
kg
- Product Description
-
Description :
BK-4B-500KG hook weighing sensor BK-4B tension and pressure sensor:
The force sensor can adopt an S-shaped structure and can be used in both tension and compression. It applies advanced sealing technology and has a sealing level of IP65. It has strong anti torsion, anti lateral and anti deviation capabilities. It has single hole structure and double hole structure, as well as bending deformation structure and shear deformation structure. Below, the manufacturer of the S-type force sensor, Shenzhen Youzhongli, will provide a detailed introduction to the relevant knowledge of this equipment to help everyone have a comprehensive understanding of the product.
BK-4B-500KG hook weighing sensor BK-4B tension and pressure sensor:
On site installation case
The installation form of this type of tension sensor is the installation form of a fixed base sensor. During installation, the sensor is placed inside three fixed stop columns of a wireless hook scale. Therefore, it is required to be used in situations where the temperature change range is not large. Its advantage is that it can improve the stability of the scale body and is easy to install and debug. When installing the weighing sensor, attention should also be paid to:
To prevent high current from flowing through the sensors, short-circuit plates should be installed between the sensors to prevent accidental high current from burning them out. Even so, the best way to perform electronic weighing when welding is to remove the pressure sensor and install the weighing sensor after several operations are completed.
2. The indenter should be made of 20mm thick chrome steel, and the bottom surface of the indenter should be machined into a circular arc with a radius of at least three times the radius of the sensor dome. Heat treatment should be carried out to increase the hardness of the indenter. The fixing plate should be made of 45 steel with a thickness of not less than 20mm, and the levelness during installation should not exceed ± 0.5 °.
3. Moving parts such as ball bearings should slide freely and should not be stuck or corroded
AfterSalesService :
Key words:- BK-4B-500KG Hook Scale Sensor
