Production of various materials such as stainless steel camel hump support 316L 304 10276

Description :

　　Production of various materials such as stainless steel camel hump support, packing support, 316L 304 10276, etc

　　The characteristics of our company's stainless steel hump support are:

　　(1) Good rigidity, allows for large loads, and can reliably withstand various pressures applied to it.

　　(2) Has excellent fluid dynamics performance. The gas and liquid channels are separated, and the gas phase is sprayed towards the packing layer through the side openings on the support plate, while the liquid phase flows towards the lower packing layer through the openings at the bottom of the support plate. Therefore, the gas-liquid flow is unobstructed and evenly distributed, which can also avoid mutual entrainment between the gas-liquid and allow for high gas-liquid flux. The liquid spray density can reach up to 240m3/m3h, and the pressure drop during normal operation is about 62Pa, which is less than 200Pa.

　　(3) Filling particles or fragments are not easy to block the hole opening. For filling materials smaller than DN25, a layer of 300mm high large filling material can be first laid on the support plate, and then small filling materials can be stacked.

　　(4) Lightweight and material saving. It can be made of materials such as metal, plastic, ceramics, etc.

　　(5) The single unit combination structure is easy to install from the manhole.

　　(6) The three-dimensional structure of the support plate is conducive to increasing the opening area, making the opening area more on the left and right. The principle of opening area is that the opening rate must be greater than the porosity of the packing layer, otherwise the support plate forms a "bottleneck" zone, reducing the tower load. The opening area is related to the structure, material, and tower diameter, generally accounting for 70% of the tower section. For metal support plates, it should be selected around.

　　Stainless steel hump support product introduction:

　　Filler support grid is a structurally simple and commonly used filler support device. It is placed on the support ring welded. Cast iron support grating has been widely used in the chlor alkali and sulfuric acid industries for a long time. However, when filling bulk packing, the enlarged cross diaphragm ring can be placed on the grid Flat noodles for filling, and its size and specification depend on the type of packing in the tower. If the filling inside the tower is too small, several layers should be placed and the size should be gradually reduced to prevent the scattered packing from falling off. This can also increase the distance between the grid plates, saving materials and processing time.

　　Hump supportWidely used in fields such as oil refining, chemical engineering, fertilizers, ethylene and oxygen production, with large diameters of over 10 meters already in use. In addition, there are bell shaped supports, corrugated mesh supports, grid shaped supports, etc.

　　Hump supportPackaging method: wooden crate;

　　Hump supportTransportation method: truck transportation;

　　Material: PP/PVC/CPVC/PVDF/PTFE, etc;

　　Material: 304/304L/316/316L/duplex steel/titanium, etc;

　　Dier Chemical Packing Co., Ltd. in Pingxiang City, Jiangxi Province has been engaged in research, development, and design of various tower internals products, as well as plastic, metal, ceramic bulk and regular packing materials for many years. We can produce various materials according to customer needs:

　　Our company (Jiangxi Pingxiang Dier Chemical Packing Co., Ltd.) is committed to providing customers with satisfaction and peace of mind; Our company has been signing long-term technical cooperation agreements with more than 10 domestic chemical research units for many years, and has hired senior technical management personnel from Tsinghua University and Tianjin to provide product design, processing, production, installation, and services.

AfterSalesService :

• Stainless steel hump support