Propane storage tank pressure vessel manufacturer offers discounted prices for liquefied gas storage tanks

Description :

　　Liquefied gas storage tanks result in relatively low heat loss, while insulation is about twice as good as manual foaming. Temperature can be controlled by temperature sensors that can be extended to various locations. These temperature sensors can sense changes in temperature and transmit them to the control center through numerical control, providing hot water while also reducing energy consumption. The commonly seen stainless steel water tanks in the market have two temperature sensors. If the structure of the tank opening is changed arbitrarily, the outlet for cold water and the outlet for hot water will be too close. When the heat of hot water increases, if a large amount of cold water is input, the water tank will release a large amount of heat at this time. Common damage faults of the float ball valve in liquefied gas storage tanks include: the float ball valve is stuck at the top of the water tank, the float ball valve is stuck by the pump pipe, and the float ball valve does not discharge water; The working condition of the float valve cannot be seen in the liquefied gas storage tank. The float valve sinks due to water ingress and is flattened; The float valve is malfunctioning, the connecting rod is bent, and the float valve is normally open.

　　Next, we will analyze the reasons for the damage and failure of the floating ball valve in liquefied gas storage tanks: Improper positioning and construction of the water inlet hole of the floating ball valve in liquefied gas storage tanks can cause it to be too close to the top, or the installed floating ball valve may not match the facilities; This is due to the non-standard installation process, which caused the float valve to get too close to the pump pipe, resulting in it getting stuck; Blockage of the floating ball valve in liquefied gas storage tanks or installation of the water outlet in the opposite direction can result in no water flow; Improper installation position of the float valve results in its working condition not being visible from the inspection port; Due to improper welding of the float valve, water ingress occurred; Improper installation of liquefied gas storage tanks can cause the float valve to be flattened, thereby increasing the stroke of the ball valve; The bending of the connecting rod of the float valve is caused by insufficient strength or poor material corrosion of the rod.

AfterSalesService :

• Propane storage tank pressure vessel manufacturer