The single hook lifting weight of the motor cover sand cleaning and shot blasting machine is used for high efficiency in sand cleaning and rust removal

Description :

　　Purpose of hook shot blasting machine: This type of cleaning machine is suitable for surface cleaning or strengthening treatment of small and medium-sized castings and forgings in industries such as casting, construction, chemical, motor, and machine tools. Specially suitable for surface cleaning and shot blasting strengthening of castings, forgings, and steel structural components with multiple varieties and small batches, to remove a small amount of sticky sand, sand cores, and oxide scales on the surface of the workpiece; Also suitable for surface cleaning and strengthening of heat-treated parts; Especially suitable for cleaning slender and thin-walled parts that are not suitable for collision.

　　The shot blasting cleaning room consists of a chamber shell and a protective plate. The dust removal port is set on the rear wall. The shell of the shot blasting cleaning room is a welded structure of steel plates and steel sections, which is a sealed and spacious operating space for shot blasting cleaning of workpieces. Two sets of QX30 shot blasting wheel assemblies are installed on one side wall of the shot blasting cleaning room to ensure comprehensive shot blasting cleaning of the cleaned workpiece. The area inside the chamber that is directly shot by the shot blasting machine is lined with ZGMn13 with a thickness of δ 12, while other areas are protected by 65Mn plates. The protective plates are tightened with protective nuts for easy disassembly and replacement when necessary. The lower part of the chamber is surrounded by steel plates to form a sloping funnel, allowing the pellets to flow into the screw conveyor at the bottom. The steel plate is also covered with protective plates for protection. Above the spiral conveyor, there is a steel leak plate, and above the leak plate, there is a wear-resistant rubber plate. When in use, the wear-resistant rubber plate should be laid in front of the shot blasting machine to protect the steel leakage plate below and extend its service life. The standard configuration of this machine is manual door opening and closing. This machine is designed in the form of a double door, with wear-resistant rubber protective plates laid on the inside of the door, using steel pressure plates and tightened with hexagonal refined nuts; There are foam rubber strips around the gate to effectively seal the gate; There is a pill collection slot below, which collects a small amount of pellets taken out when opening the door into the chamber to prevent them from falling to the ground and causing people to slip and get injured. There is an oil cup on the door shaft of the gate to regularly lubricate the bearings inside the gate leaf.

AfterSalesService :

• Motor cover sand cleaning and shot blasting machine