Renovation of Aluminum Template for Mesh Belt Shot Blasting Machine Shandong Mesh Belt Shot Blasting Machine Factory

Description :

　　Our company has visited many domestic and foreign enterprises to independently design, research and develop, and produce aluminum template shot blasting cleaning equipment based on the requirements of aluminum template manufacturers and users. It is specifically designed for cleaning the surface of old aluminum templates adhered with cement. Its product features are:

　　The layout of the shot blasting chamber and shot blasting wheel is determined through three-dimensional dynamic projection simulation by computer.

　　2. Adopting four QD034 high-speed belt linked high-speed shaft seat centrifugal shot blasting machines significantly improves cleaning efficiency, achieves satisfactory cleaning quality, and effectively avoids the occurrence of bullet blockage and motor burnout.

　　3. The thickness of the hot zone of the protective plate reaches 70mm, and the special pill dividing structure (guided pill wing) increases the utilization rate of the pellets to 95%. In China, this technology is used by our company.

　　4. The shot blasting chamber body is welded with 10mm thick steel plates to form a box shaped structure, with high strength and no vibration. Internally, 12mm ZGMn13 is used, and the protective plate is connected with a stopper, effectively extending the service life of the chamber and fully utilizing the rebound of the projectile to form a secondary cleaning.

　　5. The front and rear sealed chambers adopt a V-shaped device with leaf spring sealing, which can effectively prevent projectile splashing and reduce component wear and tear on the seal. The remaining sealing layers are sealed with high wear-resistant rubber plates.

　　6. In order to reduce the friction on the bottom hopper during the falling process of the pellets, buffer angle steel is included on all hoppers.

　　7. In order to prevent deviation of the workpiece during the process of loading and unloading, stop plates are installed at both ends of the mesh belt.

　　8. The number of shot blasting machines can be determined based on the size of the workpiece, which can reduce unnecessary energy waste and minimize unnecessary damage to the equipment.

AfterSalesService :

• Mesh belt shot blasting machine