Steel skeleton lightweight slab, Henan Anyang mezzanine loft small floor slab
Category:
building materials/Waterproof and fireproof functional materials/insulation material
Model:
Custom Drawing
Brand:
Shen Bo
model:
Custom Drawing
material:
Cement foaming
Soft and hard conditions:
hard
Retail Price
130.00USD
重量
kg
- Product Description
-
model Custom Drawing
material Cement foaming
Soft and hard conditions hard
Description :
Steel skeleton lightweight slab, Henan Anyang mezzanine loft small floor slab
The core plate is made of inorganic material, with good stability, aging resistance and service life equal to that of concrete material
Diameter of steel wire at the bottom of the board
Above, the thickness of the protective layer
Above and with a moisture absorption rate lower than
The board has strong resistance to gas corrosion such as acid and alkali
After the second freeze-thaw cycle, there was almost no change in volume and strength.
The board has excellent insulation performance, low thermal conductivity, and the overall heat transfer coefficient of the board can reach
Meet the insulation and energy-saving requirements of buildings in high-altitude regions
The board has excellent thermal insulation performance, and the outer side of the board is heated to
At that time, the temperature inside the board was only
It is an ideal building insulation material for high-temperature areas.
Waterproof:
The core board is made of inorganic material, which is non combustible and does not burst or release toxic gases in fire, making it an excellent refractory material; The fire resistance of the entire board is greater than
Production, installation, stacking, transportation, and maintenance
8.1 The main ribs of the lightweight steel frame plate shall be sandblasted for rust removal, and the surface of the steel main ribs shall be thoroughly rust removed, with a rust removal grade of St3. If rust is found during use, measures should be taken in a timely manner. The connection between the steel main rib and the end rib, as well as the stiffening rib, is welded with a welding foot size of 4mm full
Welding, the welding quality complies with the relevant current national standards.
8. Welded steel wire mesh is used inside the lightweight steel frame slab, with short span small b Sa} 150 as the lower reinforcement, and the length extending into the support shall not be less than SOmm; Long span b 3 secret 200 is the upper reinforcement, which extends into the support for a length of not less than 30mm, and is welded one at a distance from the edge ribs unless otherwise specified.
8.3 The suspension rod of the steel skeleton lightweight board ceiling should be connected to the edge ribs and should not be connected to the core board.
When stacking lightweight plates with a steel skeleton of 8.4 SB, the height of each stack should not exceed 10 pieces, and wooden pads should be placed flat and aligned vertically. During loading and transportation, the overhanging length of the board should not exceed 300mm.
AfterSalesService :
Key words:- Steel skeleton lightweight plate
More Products
