Fully automatic grouting small pipe taper machine, precise constant steel pipe taper forming machine, manufacturer's address

Description :

　　Fully automatic grouting small pipe taper machine, precise constant steel pipe taper forming machine, manufacturer's address

　　The small pipe taper machine plays a crucial role in the construction industry. A small conduit is an indispensable step in construction, as it can effectively penetrate into the wall. The pointed end at the front is relatively easy to penetrate, and the small holes on the steel pipe wall are added to enhance the strength of the surrounding rock. The small tube taper machine has a fast taper speed, and the taper of a pipe can be completed within one minute.

　　The GL50 advanced small tube punching machine has an intelligent and user-friendly interface design, which is not only intuitive but also easy to operate. Product processing can be carried out simply by adjusting the interface parameters, eliminating the need for programming. The product has a wide range of applications, and users only need to replace different molds to achieve punching processing for different pipe fittings. Changing the punching needle can punch holes of different shapes. Can work continuously and with higher quality. Easy mold replacement, short machine adjustment time, high work efficiency, strong continuity, unlimited number of punching holes, and processing of piercing holes. Whether it is full hole processing or half hole processing, it can be completed in one go without changing the mold. Henan Gengli Small Pipe Tip Machine 3 seconds one fully automatic grouting small pipe tip shrinking machine Jingheng steel pipe tip shrinking forming machine manufacturer address.

　　Precautions for the operation of the small tube shrinking machine:

　　1. At the site of using a punching machine, the hole position and surrounding obstacles such as stones should be removed according to the requirements of the punching machine manual.

　　2. The distance between the work site and the power transformer or main power supply line should be within 200m, and the voltage drop during startup should not exceed 10% of the rated voltage.

　　3. Electric motors and control boxes should have good grounding devices.

　　4. Before installation, it is necessary to check and confirm that there are no changes to the punch rod and its components.

　　5. After installation, the centerline of the punch rod and power head is allowed to deviate by 1% of the total length.

　　6. When installing the punch rod, start from the power head and install it section by section downwards.

　　7. It is not allowed to lift and install the required length of the punching rod all at once after connecting it on the ground.

　　8. Before installing the power head, the pulley assembly should be removed and the steel wire rope should be wound properly.

　　9. The selection of steel wire rope should be equipped according to the requirements specified in the instruction manual.

　　10. After installation, the frequency of the power supply should be the same as the pointer on the frequency conversion switch inside the control box. If they are different, the frequency conversion switch should be used for conversion.

　　11. The punching machine should be placed steadily and firmly. For automotive punching machines, the support legs should be set up, the tires should be lifted up, and the tappet should be adjusted automatically or with a plumb bob to keep it vertical. The fully automatic grouting small pipe shrinking machine and the precise constant steel pipe shrinking forming machine manufacturer's address.

AfterSalesService :

• Fully automatic grouting small pipe shrinking machine