Support grouting small pipe punching machine, precision rock reinforcement small pipe punching machine

Description :

　　Support grouting small pipe punching machine, precision rock reinforcement small pipe punching machine

　　Punching machines have been widely used in tunnel construction. The punching machine can set 200 holes on one pipe, and the machine is matched with a servo motor. The hole spacing error is within ± 0.3mm, and the punching speed is fast, which greatly improves the manual cutting speed compared to before. The circular holes are also relatively neat and beautiful.

　　During the grouting construction period, it is necessary to monitor whether the groundwater is contaminated and prevent the grouting slurry from overflowing the ground or exceeding the grouting range

　　These parameters should comply with the instructions provided in the random instruction manual. (4) When the CNC device is connected to the machine tool and powered on, an emergency stop button should be prepared at the same time as the power is turned on, in case of emergency situations where the power can be cut off at any time. (5) In manual mode, feed each axis at low speed and observe whether the machine direction and coordinate values are displayed correctly. When changing the specifications and adjusting the position of the slider in the operation process of the fully automatic steel cage winding machine, it is necessary to confirm that the bolts are tightened to avoid accidents caused by the slider flying out during welding. When the equipment runs abnormally, it should be stopped immediately to check the cause of the fault, and after the fault is eliminated, the welding should be restarted. All power sources of the equipment (including adjusting the position of travel switches and proximity switches) should be cut off completely. Only adjustments can be made, and it is strictly prohibited to do so while the equipment is live. Before powering on the equipment, it is necessary to ensure that all personnel stay away from the equipment (including the supply reinforcement of the ring reinforcement, and must not cross the ring reinforcement) to avoid danger. Roll welding machine is used in the welding support grouting small pipe punching machine for precise rock reinforcement small pipe punching machine.

　　The lower limit position ensures accurate and clear operation. Using servo motor actuation, the feeding speed can be quickly adjusted and the degree can be high, which can greatly increase production. Operation steps of advanced small pipe drilling machine: 1. Connect the oil pump and working head with a quick connector; 2. Select the corresponding upper and lower molds, install the upper mold first and then the lower mold. When installing the upper mold, first screw the positioning screw out of a certain position before installing the lower mold. Be sure to place it in place, and then tighten the positioning screw to start the operation; Otherwise, the workpiece will get stuck in the upper mold. As a common type of equipment, stainless steel punching machines are widely used nowadays and are involved in many industries. Their functions are also worthy of recognition. Through continuous experience and summarization, the performance advantages of this product are quite obvious, roughly including the following aspects: cost savings: compared with general punching machine equipment, its footprint is very small. And the cost consumption is only three-quarters of that of ordinary equipment, such as support grouting small pipe punching machine, precision rock reinforcement small pipe punching machine.

AfterSalesService :

• Support grouting small pipe punching machine