Subway small pipe punching machine, precise slope support small pipe forming machine

Description :

　　Subway small pipe punching machine, precise slope support small pipe forming machine

　　Punching machines have been widely used in tunnel construction. The punching machine can set 200 holes on one pipe, and the machine is matched with a servo motor. The hole spacing error is within ± 0.3mm, and the punching speed is fast, which greatly improves the manual cutting speed compared to before. The circular holes are also relatively neat and beautiful.

　　During the operation of the small tube punching machine:

　　(1) When starting the small tube punching machine, be careful not to let the human body enter the range scanned by the punching.

　　(2) During the operation of the small pipe punching machine, all personnel are prohibited from entering the space scanned by the pipe fittings.

　　(3) When adjusting (molds), the adjuster should press the button themselves to make the adjustment. It is forbidden for one person to adjust on the machine and another person to operate on the control cabinet.

　　(4) When adjusting the machine tool or driving an empty car, the core rod should be removed.

　　(5) After using the small pipe punching machine for a period of time, it is necessary to check the degree of gear tension and maintain the same clearance between the gear and the rack.

　　(6) Before returning the punch, the operator must ensure that the core head is inside the pipe or that the core shaft is not obstructed during punching return. Otherwise, the punch or core rod may be bent or broken by the subway small pipe punching machine and the precision slope support small pipe forming machine.

　　Technical Instructions for Using Small Pipe Punching Machine

　　1. Raise the hydraulic hammer to the top, place the lower part of the steel pipe pile on the pile position, align the upper part with the pile head of the lower part of the hydraulic hammer, press down on the steel pipe pile, and then start the hammer to drive the pile. The pile head maintains pressure on the steel pipe pile until the steel pipe pile is driven to the specified size.

　　2. Due to the poor working environment and high impact vibration of this machine, it is necessary to observe the dynamics of each part at all times during operation. If abnormal noise or other abnormal phenomena occur, the machine should be stopped at any time for inspection and troubleshooting before continuing to use. If hydraulic system joints are found to be leaking or components are loose, the machine should be stopped for adjustment and tightening. After normal operation, it can continue to be used.

　　3. Before the end of each shift, the hydraulic hammer should be lowered to a lower position, and the remaining oil cylinders and piston rods should be shortened. If the distance shifts, the column should remain tilted back.

　　4. Regular inspections should be conducted on the execution components, accessories, and electrical parts of the small pipe punching machine, as well as the connection of the motor wiring to the subway small pipe punching machine and the precision slope support small pipe forming machine.

AfterSalesService :

• Subway small pipe punching machine