Dust removal fan for tunneling machine Shandong mining dust removal fan supports customization

Description :

KCS mining wet dust removal fan, KCS mining wet dust removal fan manufacturer, mining KCS wet dust removal fan, mining explosion-proof wet dust removal fan, mining wet dust removal fan parameters, mining wet vibrating wire dust removal fan, mining wet dust removal fan price, KCS-100D mining wet dust removal fan, dust removal fan mining fan, dust removal fan mining dust removal fan, mining dust removal fan price, mining dust removal fan parameters, mining vibrating wire dust removal fan, mining explosion-proof dust removal fan

As we all know, coal dust has basic conditions: (1) coal dust itself has properties; (2) Coal dust is in a suspended state with a concentration of 45-2000 grams per cubic meter; (3) Ignition temperature: 650-750 ℃; (4) The oxygen concentration reaches over 18%. So long-term mining in coal mines will produce a certain concentration of coal dust underground. If dust is not removed in time, it will lead to major accidents. Looking back at gas and coal dust accidents, each one is shocking! Based on this, we need to do a good job in coal dust removal and choose reliable mining dust removal equipment. Let's take a look at the KCS produced by Shandong Coal Machinery Mining Equipment Co., LtdMining wet dust removal fan.

1The mining wet dust removal fan is composed of a coal mine extraction explosion-proof local ventilation fan and a wet screw string dust collector assembly. The installed fan is an axial flow explosion-proof extraction local ventilation fan. As long as the working point design of the dust collector matches the resistance characteristics of the fan, the overall performance of the machine can be guaranteed to meet the design specifications.

2The wet dust removal fan for mining shall comply with the standard MT159-2005 "General Technical Conditions for Mining Dust Collectors" and Q/DF005-2013 "KCS Series Mining Wet Dust Removal Fan Enterprise Standard".

3The dust removal fan must pass the inspection before leaving the factory. Before use, carefully read the instruction manual, refer to the precautions in the manual, check whether the whole machine is in good condition, and follow the instructions for the electric motor used in the coal mine undergroundAn allAccording to the regulations, a pre well inspection must be conducted before going down the well. Only those who meet the requirements can go down the well. Perform a 5-minute ground power on test run to inspect and observe the firmness of each component, whether the connections are loose, and whether there are any abnormal phenomena, and record them in the file. When going into the well for on-site use, first connect the water supply spray system, open the inspection door, and observe whether the spray is normal. The spray should cover the filter end face completely and evenly, andYi DingPressure (3kg/cm2). If the spray head is blocked, clean it.

4After starting the fan for 2 minutes, pay attention to observing whether the dust collector is dehydrated normally, whether there is obvious water mist at the exhaust outlet, and whether the drainage outlet has smooth water flow.

5It is strictly prohibited to operate without water spray or without installing gas power off automatic protector. The electrical protection of the whole machine is grounded (according to the underground coal mineAn allRegulations).

Practice has shown that,The KCS mining wet dust removal fan can not only adapt well to the characteristics of coal mines in China, but also effectively remove dust while being explosion-proof. Learning from others' strengths and exploring innovation have always been our persistent pursuit. Therefore, Shandong Coal Mining Equipment Co., Ltd. will spare no effort to solve practical problems in coal mine sites. We warmly welcome customers and friends to visit and guide us for consultation and cooperation.

AfterSalesService :

• Shandong Mining Dust Removal Fan