TWYX high-pressure fan RB-81D-3 vortex high-pressure fan 7.5kw high-pressure fan manufacturer

Description :

　　TWYX fan RB-81D-3 vortex high-pressure fan 7.5kw high-pressure fan manufacturer

　　Low noise vortex blower

　　New design can eliminate the high frequency and special noise reduction materials generated during wind cutting, significantly reducing the noise ratio

　　The price, parameters, after-sales service, and selection of all air blowers are all made of ADC12 material, which is relatively hard in the world. The blades and covers of all air high-pressure blowers and all air high-pressure blowers are made of the same material as Mercedes Benz wheel rims.

　　2、 The bearings of the all wind high-pressure fan adopt high-speed and high-temperature resistant imported bearings, with 2800 revolutions per minute at 50Hz and 3450 revolutions per minute at 60Hz, without lubrication and maintenance. Supports 24-hour long-term operation, with stable and reliable performance.

　　3、 The inlet and outlet of the all wind high-pressure fan are equipped with built-in soundproof pipes to achieve low noise.

　　4、 Full pressure high-pressure fans below 1.1KW can be used at full pressure.

　　5、 The pressure of the all wind high-pressure fan is stable, and it has been proven through practical applications in water treatment and electroplating that the stirring is uniform and the water waves roll at the same height.

　　6、 Under the same power and pressure, the flow rate of the all wind high-pressure fan is greater than that of similar products.

　　7、 The cover of the all wind high-pressure fan adopts a sheet-like heat dissipation design, which is equivalent to a motorcycle engine heat dissipation device, greatly reducing the temperature during fan operation.

　　8、 The all wind high-pressure fan adopts the principle of bearing front design, with two bearings placed at the front end of the fan blades and the rear end of the motor, achieving a relatively good dynamic balance configuration and facilitating heat dissipation. (The reason is that there are heat dissipation fins at the front end of the fan blades for heat dissipation, while the bearings at the back end work under the built-in cooling fan of the fan, thus keeping the bearings working for a long time at low temperatures.)

AfterSalesService :

• TWYX high-pressure fan