Installation and construction of Xinjiang welding mesh isolation fence Urumqi isolation fence manufacturer

Description :

　　Although the installation of welded mesh isolation barriers is simple, it is necessary to pay attention to the quality of the installation, so there are certain requirements for the installation personnel. The following are several precautions during the installation process of the guardrail network:

　　1. The frame guardrail fence is made of impregnated wire mesh fence, with a height of 1800mm

　　2. The cast-in-place soil must be placed on top of the old soil and compacted. If the lower part is backfill soil, 2:8 lime soil should be used for replacement, with a thickness of not less than 600mm. The width of the replacement on both sides should exceed 600mm, and it is required to be compacted layer by layer to the foundation bottom elevation, with a compaction coefficient of not less than 0.95

　　3. The foundation of the concrete fence column shall be poured on site, with dimensions of 400mm * 400mm * 500mm, and the foundation shall be elevated 5mm above the ground. During the construction process, the flatness of the foundation must be ensured, and the foundation shall not be less than 40OX400X500mm. The riser shall be kept at the same depth of 450mm as the foundation

　　4. The gap between the lower end of the wire fence and the ground must be less than 00mm

　　5. The mesh size of the frame guardrail mesh is 150 * 75mm, the diameter of the iron wire is 3.8mm before immersion molding, the diameter of the steel pipe is 48mm, the wall thickness before immersion molding is 1.2mm, and it is inclined outward by 30 degrees. If the ground height difference of the frame guardrail mesh exceeds 5cm or there are ditches, it can be leveled first. After the slope is gentle, fill the soil at the bottom of the slope according to the construction plan. In areas with complex ground conditions, adjustments can be made according to the actual situation

　　6. The construction and installation of the guardrail fence should be carried out under the guidance of the manufacturer's technical personnel. The location of the factory gate will be determined after the access road is determined, and it should be fully connected to the side wall stack of the gate

　　Construction effect requirements: The mesh surface should have high freshness and strength, and the decoration should be prominent; The welding points are firm and effective in preventing human shear damage;

　　Efficient immersion molding for ten years to prevent rust; Easy disassembly and assembly, good reusability, and the fence can be rearranged according to needs; Environmentally friendly products can ultimately be recycled and reused

AfterSalesService :

• Xinjiang welding mesh isolation barrier