Quick installation fully insulated scaffolding _ Electric mobile quick installation scaffolding _ Insulated quick installation scaffolding manufacturer

Description :

　　Kelida Brand - Quick Installation Fully Insulated Scaffolding Construction Method and Precautions:

　　1. Install the upper end of the wheel foot or flat foot into the lower end of the adjustable foot to tightly connect the two. Adjust the height of the wheels or flat feet according to the ground conditions.

　　2. Insert the top of the adjustable foot with wheel feet into the four or five level frame (two in total) that has released the spring lock plate,

　　3. Take two horizontal support rods (marked in yellow and black with the words "horizontal support rod"), and clamp their two ends on the vertical rods of the fifth level frame respectively (you should hear the click sound of the buckle), with the buckle position slightly above the gear crossbar:

　　4. Take two diagonal support rods (marked in black with the words "diagonal support rod") and clamp one end onto two horizontal anti slip crossbars of five level brackets, leaving a gap of about 3-4 centimeters on both sides. The two diagonal support rods cross each other (such as one on the left gear and the other on the right gear); The other end is stuck on the third level horizontal anti slip crossbar.

　　Step on the brakes of the four wheels so that they cannot move. Take two more diagonal support rods and clamp them on top of the previous two diagonal support rods, then sequentially install the diagonal support rods at the back.

　　6. Take a nine space inclined ladder and hang it on the horizontal anti slip horizontal bar clamped by the second inclined support. Tighten the two inclined support bars to the vertical bar from the outside at the same height.

　　7. Take a piece of platform board and place both ends of the platform board on top of the inclined ladder, with the placement on the horizontal anti slip crossbar and staggered from the inclined ladder, that is, the platform board is on the right side of the inclined ladder.

　　8. From the inclined ladder to the platform board, take two five level frames and insert them into the two five level frames below, and insert the safety iron plate.

　　9. Follow steps 3-8 for the rebuilding process. Single width scaffolding: After the second perforated panel is erected, external support must be used; Double width scaffolding: After the third platform board is erected, external support must be used.

　　10. When building the external support, each buckle on the external support should be firmly locked onto the vertical column, and the bottom should be tightly attached to the ground without any hanging phenomenon. If external support is called, the lower end needs to be extended and inserted with a fixed pin. Each external support should form an obtuse angle of 120 ° to 140 ° with the scaffolding.

　　During the construction process, a five level frame is generally used first, followed by a four level frame, and then a three-level frame or guardrail frame. First use a nine space inclined ladder, then an eight space inclined ladder, and finally a six space inclined ladder. You can also choose an external climbing telescopic ladder.

　　If the height of the platform exceeds 10m, reinforcing poles can be used. But if the height of the platform exceeds 15m, it is necessary to use reinforcing rods. When using reinforcing rods, each reinforcing rod must be fixed with 4 connecting buckles, and the vertical rod and reinforcing rod must be firmly clamped.

　　13. Internal ladders are generally staggered and hung on horizontal anti slip crossbars, following the principle of first on the left and then on the right.

　　When the platform reaches the desired height, single width scaffolding requires perforated panels, while double width scaffolding requires one perforated panel and one platform panel each. And the hole of the perforated plate must be directly above the ladder.

AfterSalesService :

• Quick installation fully insulated scaffold