Reactor manufacturer resin production equipment with excellent craftsmanship and performance

Description :

　　Operating procedures for stainless steel reaction kettle:

　　1. Check whether the kettle, mixer, rotating parts, auxiliary equipment, indicating instruments, safety valves, pipelines and valves meet safety requirements.

　　2. Check if water, electricity, and gas meet safety requirements.

　　Stainless steel reactor is in operation

　　1. Before adding materials, the mixer of the reaction kettle should be turned on first. When there is no noise and it is normal, the materials should be added to the reaction kettle, and the amount of materials added should not exceed the process requirements.

　　2. Before opening the steam valve, first open the return valve, and then open the intake valve. The steam valve should be opened slowly to preheat the jacket and gradually increase the pressure. The pressure inside the jacket should not exceed the specified value.

　　3. The steam valve and cooling valve cannot be started simultaneously, and hammering and collision are not allowed when the steam pipeline is out of air.

　　4. When opening the cooling water valve, first open the return valve, and then open the inlet valve. The cooling water pressure shall not be lower than 0.1 megapascals, nor shall it be higher than 0.2 megapascals.

　　5. The water ring vacuum pump should be started before supplying water. When stopping the pump, the pump should be stopped first and then the water should be stopped, and the accumulated water in the pump should be drained.

　　6. Check the operation of the reaction kettle at any time and stop for maintenance if any abnormalities are found.

　　7. When cleaning the titanium epoxy (enamel) reaction vessel, do not use alkaline water to brush the reaction vessel, and be careful not to damage the enamel.

　　Attention to the use of reaction kettle

　　A reactor is a type of reaction equipment that must be operated carefully, otherwise it may be damaged due to various reasons, leading to production stoppage. There are many aspects to pay attention to when operating a reactor.

　　Firstly, it is necessary to strictly operate the reactor according to the rules and regulations.

　　Secondly, before operation, carefully check for any abnormalities. During normal operation, do not open the upper cover or touch the wiring terminals on the board to avoid electric shock; It is strictly prohibited to operate under pressure; During the nitrogen pressure test, carefully observe the changes in the pressure gauge. Once the test pressure is reached, immediately close the nitrogen valve switch; The heating rate should not be too fast, and the pressurization should also be carried out slowly, especially the stirring speed, which is only allowed to increase slowly.

　　Afterwards, when the kettle body is heated to a higher temperature, do not come into contact with the kettle body to avoid; After the experiment, the temperature should be lowered first. Do not cool quickly to prevent damage caused by excessive temperature and pressure differences. At the same time, it is necessary to unplug the power supply in a timely manner.

　　At the same time, attention should be paid to maintenance of the reaction kettle after use, so that the high-pressure kettle can have a better service life.

　　The reaction kettle is an indispensable anti-corrosion equipment in the chemical industry. Mechanical collisions, sudden temperature changes, and other factors often cause porcelain detachment, cracks, bubbles, pores, and other damage to the glaze during use. These defects are never allowed in enamel equipment, and once this phenomenon occurs, it must be repaired. The on-site repair agent of Fushilan polymer composite material is a two-component composite material composed of polymer, alloy steel powder or wear-resistant ceramic powder as the substrate, and a curing agent. Compared with ordinary resin based repair agents, polymer composite materials rely on their finer polymer structure, which gives the material stronger adhesion and excellent corrosion resistance. Polymers can even penetrate into metals, forming a tighter polymer composite protective layer. Repair process: surface cleaning → rust removal → anhydrous alcohol cleaning → Fushi Blue coating bottom repair agent → Fushi Blue coating surface repair agent → curing → use.

AfterSalesService :

• Reactor manufacturer