Reactor manufacturer

Description :

　　The reaction kettle consists of a kettle body, kettle cover, jacket, stirrer, transmission device, shaft seal device, support, etc. When the aspect ratio of the mixing device is large, multiple layers of mixing blades can be used, and it can also be selected according to the user's requirements. A jacket is installed outside the kettle wall, or a heat exchange surface is installed inside the reactor, or heat exchange can be achieved through external circulation. The support seat can be of the support type or ear type. Gear reducers should be used when the speed exceeds 160 revolutions per minute The number of openings, specifications, or other requirements can be designed and manufactured according to user requirements.

　　1. Packing sealing is usually used under normal or low pressure conditions, with a pressure of less than 2 kilograms.

　　2. In general, mechanical seals are used for medium pressure or vacuum situations, with a pressure of negative pressure or 4 kilograms.

　　3. Magnetic sealing will be used under high pressure or high volatility of the medium, usually when the pressure exceeds 14 kilograms. Except for magnetic seals that use water cooling, other sealing forms will increase the cooling water jacket when the temperature exceeds 120 degrees.

　　Attention to the use of reaction kettle

　　A reactor is a type of reaction equipment that must be operated carefully, otherwise it may be damaged due to various reasons, leading to production stoppage. There are many aspects to pay attention to when operating a reactor.

　　Firstly, it is necessary to strictly operate the reactor according to the rules and regulations.

　　Secondly, before operation, carefully check for any abnormalities. During normal operation, do not open the upper cover or touch the wiring terminals on the board to avoid electric shock; It is strictly prohibited to operate under pressure; During the nitrogen pressure test, carefully observe the changes in the pressure gauge. Once the test pressure is reached, immediately close the nitrogen valve switch; The heating rate should not be too fast, and the pressurization should also be carried out slowly, especially the stirring speed, which is only allowed to increase slowly.

　　Afterwards, when the kettle body is heated to a higher temperature, do not come into contact with the kettle body to avoid; After the experiment, the temperature should be lowered first. Do not cool quickly to prevent damage caused by excessive temperature and pressure differences. At the same time, it is necessary to unplug the power supply in a timely manner.

　　At the same time, attention should be paid to maintenance of the reaction kettle after use, so that the high-pressure kettle can have a better service life.

　　The heat transfer jacket of the reactor is generally made of ordinary carbon steel. It is a container that is placed outside the reactor cylinder to form a sealed space, which is simple and convenient. The jacket is equipped with inlet and outlet ports for steam, cooling water or other heating and cooling media.

AfterSalesService :

• Reactor manufacturer