Ground mounted box pump integrated assembly type box pump integrated water tank

Description :

　　Integrated ground tank pumpThe prefabricated integrated pump station composite BDF module uses hot-dip galvanized steel plate 3mm and 0.4mm 304/2B food grade stainless steel plate to be pressed and composite formed by equipment, so as to achieve the strength of steel plate material, corrosion resistance of stainless steel and other requirements. 2、 After compression molding, punching molding is carried out through equipment to meet the assembly requirements of standard modules. 3、 On site assembly and selection of 10 # national standard hot-dip treatment for foundation channel steel, combined with a spacing of 1 meter between each beam, and so on. 4、 Assemble according to the atlas and technical requirements, and assemble with Φ 10 * 30 hot-dip galvanized screws and environmental protection, water resistance and anti-aging adhesive strips. After the water tank is assembled and formed, install the tie bars and top columns. The reinforcement is made of hot-dip galvanized steel with a diameter of 48, and is installed horizontally and vertically at a distance of 1 meter. The top pillar is sealed with 4 hot-dip galvanized pipes of diameter 48 evenly distributed per square meter. 5、 According to the installation of the pump room and the screws on the outside of the pump room, the pump is reinforced with 12 # I-beam inside to achieve good pressure bearing effect. After installation, check and accept to ensure that all fasteners are tightened without omission. 6、 Clean up all remaining accessories and garbage in the water tank.

AfterSalesService :

• Integrated ground tank pump