60 standard box rear dump semi-trailer
Rear flip is a new type of semi-trailer dump truck developed by our company. It has the characteristics of low center of gravity and less likely to overturn when lifted. The frame and carriage have been patented, and the frame is made of 16 manganese beam plates, greatly increasing the load-bearing strength. The center of gravity has been lowered to 1.3-1.4 meters, making it less likely to sway or overturn during transportation, and significantly reducing damage to tires, leaf springs, and frames. The carriage adopts a front narrow and rear wide mode. According to the triangle principle, when the carriage is lifted, its center of gravity is relatively concentrated. When the angle of its corner line tilts to a certain angle, the corner line of the large box is perpendicular to the ground, and the two sides of its bottom horizontal line are 10 centimeters apart, so the large box will not overturn. The narrow front and rear design of the large box is more conducive to the self dumping of goods, making it less prone to blockage. The goods slide evenly, avoiding situations where one side falls and the other does not, thus preventing the vehicle from tipping over. The oil cylinder of the car is custom-made from the manufacturer, and its material strength is different from that of ordinary oil cylinders, with a one-year warranty. The rear panel of the car is locked using a mechanical device. The locking hook and rear panel automatically open during unloading to avoid blockage, especially when unloading stones, which will not hit the rear panel and reduce damage to the vehicle. This vehicle has a high cargo carrying capacity of up to 45 cubic meters (non-standard 65 cubic meters) and a weight of 80T-100T, greatly improving work efficiency. It is an alternative product to front four, rear eight, and side dumping (front four, rear eight, pull 25 cubic meters). The lifespan of the front four and back eight frames is already limited to three years, while the ten meter long frame that flips over after ten years is not a problem because of its different structure. Our company has produced a batch of rear dump trucks, which have been put on the market and have received strong feedback. The company can also design on-site according to the actual situation of customers. For difficult to unload clay, our company can install pneumatic devices to solve the problem of incomplete unloading of dump trucks.
