YT4-6A hydraulic slider sales hydraulic slider

Description :

　　The structure of YT4-6A hydraulic slider consists of front and rear hydraulic valves fixed in the same direction on the outer wall of the cylinder body, and positioning shafts fixed on opposite sides of the cylinder body outer wall between the two valves; The cylinder body is located in the longitudinal long hole on the fixed seat through the positioning shaft; The bottom of the fixed seat is fixed with a bottom plate, which is lifted upwards near one end of the piston rod; The top of the fixed seat is fixed with a choke seat, and the groove shaped structure on the upper part of the choke seat tilts backwards and forms an angle of 20 ° -24 ° with the horizontal plane. The design of this utility model is reasonable, the hydraulic injection gun separates the injection from the cylinder body, the pusher is easy to move, and the two ends of the cylinder body are adjustable; The piston rod can make normal contact with the coal blocking plate when connected, extending the service life of the equipment.

　　YT4-6A hydraulic slider parameters rated thrust 39.2kN

　　Rated recovery tension 9.3kN

　　Pushing speed (handle reciprocating once) 17mm

　　Lift the handle 7mm

　　Press the handle down 10mm

　　Longitudinal inclination angle during travel

　　60 ° when the pump body end is low

　　When the pump body is at a height of 14 °

　　Enhancement factor ≈ 90 times

　　Dimensions (when the piston rod is fully retracted)

　　Travel 600mm 855 × 135 × 210

　　Travel 800mm 1055 × 135 × 210

　　Usage weight

　　Travel distance 600mm 32.5kg

　　Travel 800mm 38kg

　　zmjt055

AfterSalesService :

• Hydraulic slider