Shandong manufacturer supplies square 304 stainless steel water tank

Description :

　　Shandong manufacturer supplies square 304 stainless steel water tankIt is a newly developed product of our factory, gradually gaining popularity in the market. The BDF prefabricated stainless steel water tank is made of BDF single plate (3mm galvanized steel plate and 0.4mm SUS304)

　　The composite steel plate, which is formed by composite molding of stainless steel, is assembled with sealing materials, metal components, and piping systems, and has the following characteristics:

　　1. The combination size is arbitrary. 0.125-2000 cubic meters of water tank can be assembled according to user needs.

　　2. The water tank seal adopts a specially developed standardized product - sealing tape, which has the advantages of non-toxic, water-resistant, and oxidation resistant sealing performance. The service life is over 50 years.

　　3. The water tank has good hygiene conditions. The part in contact with water is molded from stainless steel sheet metal.

　　4. The water tank has high structural strength. The reinforced part is molded from galvanized steel sheet. The new structural mode adopts double tension bars for each layer, and the bearing capacity of the internal main force points is doubled, greatly enhancing the load-bearing capacity of the water tank. Externally available

　　Adopting the integral welding mode ensures long-term use without tearing, fundamentally solving various faults caused by problems with the tensioning bars during long-term use of the water tank. Traditional stainless steel water tanks use stainless steel angle steel or U inside

　　The reinforcement method of stainless steel bars, due to being completely immersed in water, often results in internal tension bar breakage or pulling apart under the action of water stress and corrosion during long-term use. In addition to affecting the normal use of users, it is also very

　　It may cause more economic losses.

　　5. Strong applicability, strong corrosion resistance, and long service life. The module adopts a modular composite design and is installed with screws. Avoid the disadvantage of severe chromium removal and easy corrosion of stainless steel during high-temperature welding. During the welding process of traditional stainless steel water tanks

　　Oxidation is inevitable in all solder joints, and even with slight surface treatment, there is still a high risk of solder joints leaking due to water corrosion during use, which has become a problem that has plagued the industry for many years.

　　6. The water tank module is easy to disassemble and assemble. After disassembly, it can be thrown in any combination.

　　7. Strong applicability, easy installation, and no need for specialized equipment.

　　8. Environmentally friendly, energy-saving, and free from secondary pollution.

　　9. Diversity in appearance colors. Users can freely choose the color of the water tank's exterior according to their requirements.

　　The geometric dimensions of concrete foundation shall be formulated in accordance with the relevant provisions of GB02S101. The height difference of the concrete foundation plane is less than 5mm

　　Installation, construction, and acceptance of BDF stainless steel water tank

　　There is a standard power supply on the construction site. There is a maintenance space of ≥ 500mm around the water tank. Appearance inspection shows no rust or pollution: filled with water for 2-3 hours, the box body shows no obvious deformation, and the welds have no leakage, which is considered qualified

　　The use, maintenance, and upkeep of prefabricated BDF stainless steel water tanks

　　When piping, do not apply excessive load to the inlet and outlet of the piping. Do not directly apply the weight of valves and large-diameter pipes to the water tank inlet. If necessary, set up pipe supports to support the expansion, contraction, and vibration of welded pipes

　　Flexible expansion joints must be installed.

AfterSalesService :

• 304 stainless steel water tank