OPGW fiber optic cable anti vibration hammer, pre twisted wire anti vibration hammer, electrical anti vibration fittings, fiber optic cable anti vibration

Description :

　　OPGW fiber optic cable manufacturer OPGW power communication fiber optic cable

　　Suspension clamp:

　　Structure and Materials:

　　Aluminum Clamp Plate - Made by pressure casting corrosion-resistant aluminum alloy, this aluminum alloy has stable chemical properties, good resistance to atmospheric corrosion, and good mechanical properties.

　　Rubber fixture - composed of rubber and central reinforcement, it has ozone resistance, chemical resistance, weather aging resistance, high and low temperature performance, high strength and elasticity, and small compression deformation.

　　Bolts, flat washers, spring washers, nuts, closed pins, U-shaped hanging rings - electrical standard components.

　　Pre twisted wire for wire protection - an aluminum alloy wire customized according to predetermined mechanical properties and chemical composition, with high tensile strength, hardness, good elasticity, and extremely strong rust prevention ability, which can be used for a long time in harsh weather environments.

　　Outer pre twisted wire - the same as the pre twisted wire of the protective wire.

　　Remaining cable rack:

　　Purpose: Used for placing surplus optical cables during fiber optic cable splicing. Generally, each splice box is equipped with a surplus cable rack.

　　Ordering Notice: The surplus cable rack is available in two types: pole and tower. If it is for pole use, a pole must be provided for use

　　Connector box:

　　Purpose: Mainly used for connection protection of OPGW optical cable joints.

　　Structural features:

　　a. The fiber optic joint and excess length adopt laminated fiber storage, and the joint protection form is reinforced with heat shrink tubing.

　　b. The joint box adopts sealing rings and silicone seals, which are easy to operate and can be repeatedly opened, and easy to use and maintain.

　　c. The fiber optic cable splice box can be grounded according to requirements and equipped with specialized tower or pole mounting brackets.

　　Shock hammer:

　　Composition: Galvanized cast iron hammer head, hot-dip galvanized steel strand, aluminum alloy wire clamp, stainless steel bolt, etc.

　　Purpose: To eliminate or reduce the vibration caused by wind energy during the operation of optical cables to protect them and fittings.

　　Features: Adopting a typical Harrow design, its basic principle is dynamic energy absorption, with a frequency coverage range of 6Hz-150Hz and four resonant frequencies within this range, which can meet the needs of various types of OPGW and has a very effective vibration reduction effect.

AfterSalesService :

• opgw cable