ADSS fiber optic cable manufacturer fiber optic cable all dielectric self-supporting fiber optic cable ADSS-24B-300M-PE fiber optic cable

Description :

　　The design of ADSS optical cable line engineering is significantly different from traditional overhead and buried optical cable line engineering. In ADSS optical cable engineering, designers should mainly consider the following issues. Understanding of the situation of transmission and distribution lines intended to install ADSS optical cables (1) Voltage levels of transmission and distribution lines: Generally speaking, the voltage levels of transmission and distribution lines used for hanging ADSS optical cables are 10, 35, 110, 220KV, etc. (2) The form of poles (towers) for power transmission and distribution lines: Its purpose is to select the installable positions for optical cables. (3) The distance between each pole of the transmission and distribution line: The representative pole distance of the line can be calculated from the distance between each pole. (4) The position of the end pole and tension pole of the transmission and distribution line: the length of the tension section can be calculated. For long-distance high-voltage transmission and distribution lines, the tension section is very important. Non tension rods can only withstand vertical forces, while tension rods can withstand horizontal forces, providing tension for power lines. The tension on ADSS optical cables can only act on the tension rods. (5) The sag of the conductor and the sag of the optical cable: The sag of the optical cable is determined by the sag of the conductor (small sag and sag) and the installation position of the optical cable on the tower, ensuring that the optical cable can maintain a safe distance from the conductor in winter (small sag), summer (sag), and wind conditions.

AfterSalesService :

• ADSS fiber optic cable manufacturer