Chimei ABS PA-709S Taiwan Chimei High Impact Pipe Extrusion Pipe Furniture Large Container
Category:
Rubber and plastic/General plastic/ABS
Model:
Brand:
Taiwan Qimei
Retail Price
14.00USD
重量
kg
- Product Description
-
Description :
Qimei ABSPA-709S Taiwan Qimei High Impact Pipe Extrusion Pipe Furniture Large Container, etc
mechanical properties
ABS has excellent mechanical properties, excellent impact strength, and can be used at extremely low temperatures. ABS has excellent wear resistance, good dimensional stability, and oil resistance, and can be used for bearings under moderate loads and speeds. The creep resistance of ABS is greater than that of PSF and PC, but smaller than that of PA and POM. The bending strength and compression strength of ABS are relatively poor among plastics. The mechanical properties of ABS are greatly affected by temperature.
thermal properties
The hot deformation temperature of ABS is 93-118 ℃, and the product can be further increased by about 10 ℃ after annealing treatment. ABS can still exhibit certain toughness at -40 ℃ and can be used within the temperature range of -40~100 ℃.
Electrical properties
ABS has good electrical insulation and is almost unaffected by temperature, humidity, and frequency, making it suitable for use in most environments.
Environmental performance
ABS is not affected by water, inorganic salts, alkalis, and various acids, but is soluble in ketones, aldehydes, and chlorinated hydrocarbons. It can undergo stress cracking when corroded by glacial acetic acid, vegetable oil, and other substances. ABS has poor weather resistance and is prone to degradation under the action of ultraviolet light; After six months outdoors, the impact strength decreased by half.
PA-709S Physical Property Table
Basic Performance Rating Unit
Melt flow rate
(220℃×10kg)4.5 g/10min
(200℃×5kg)0.4 g/10min
Physical performance rating unit
Flammability (File No. E56070 UL&C-UL) 1/16 "HB
Mechanical performance rating unit
Bending strength 560 kg/cm
Bending elastic modulus 2.0 × 10 kg/cm
IZOD impact strength
(1/8")8.1 ft.lb/in
(1/4")7.2 ft.lb/in
Rockwell hardness 100 R
IZOD impact strength (1/4 ") 39 kg.cm/cm
Tensile strength 4950 lb/in
Bending strength 8000 lb/in
Bending elastic modulus 2.8 × 10 lb/in
Elongation rate 40%
IZOD impact strength (1/8 ") 44 kg.cm/cm
Tensile strength 350 kg/cm
Unit testing method for thermal performance rating
Heat Deflection Temperature
86(187) ℉
96(205) ℃
vicat softening point
106 ℃
223 ℉
AfterSalesService :
Key words:- Qimei ABS
