ZBQ27/1.5 Mining Pneumatic Grouting Pump Filling Gap Boosting Pneumatic Grouting Pump
Category:
mechanical equipment/pump/Mortar pump
Model:
ZBQ27/1.5
Brand:
Jiabang
model:
ZBQ27/1.5
Processing & Customization:
No
material:
cast iron
Drive Type:
pneumatic
Sealing method:
C3 type non-standard seal
performance:
explosion-proof
noise:
eighty-five
traffic:
twenty-seven
speed:
two hundred
Entrance and exit caliber:
fifteen
Temperature range for use:
fifty
Retail Price
4,000.00USD
重量
kg
- Product Description
-
model ZBQ27/1.5
Processing & Customization No
material cast iron
Drive Type pneumatic
Sealing method C3 type non-standard seal
performance explosion-proof
noise eighty-five
traffic twenty-seven
speed two hundred
Entrance and exit caliber fifteen
Temperature range for use fifty
Description :
ZBQ27/1.5 Mining Pneumatic Grouting PumpCharacteristics and Applications
ZBQ-27/1.5 Pneumatic Grouting Pump for Coal Mines (referred to as Grouting Pump) is mainly used in mine, tunnel, water conservancy, subway, construction, and bridge construction for grouting water blocking, filling gaps, grouting consolidation of fractured rock layers, and anchoring grouting; It is also used for repairing local defects such as frost heave in highway and railway roadbeds, as well as for soft foundation treatment; Eliminate underground hazards in flood control and rescue operations. The grouting pump has a small volume, light weight, and reliable use. It can be safely used in places that are flammable, explosive, have large temperature and humidity changes.
Pressure boosting pneumatic grouting pumpOperating Procedures
Ensure that the air source has no excessive moisture or dirt, and that there is a lubrication system in place. Optional oil mist generator provided by our factory.
The air source pipe should first be connected to the ventilation pipe to blow away debris, and then reliably connected to the grouting pump.
Firstly, immerse the inlet of the pump in clean water and slowly open the inlet ball valve to ensure that the grouting pipeline is unobstructed and there is no leakage at the sealing point.
The slurry should be mixed evenly, without lumps, but thick. Timely clean the solidified materials at the corners and edges of the bucket to prevent them from falling into the slurry.
Immerse the inlet of the pump into the slurry, slowly open the inlet ball valve, and gradually increase to the appropriate grouting speed.
After the pump stops working, it should be immediately immersed in clean water for flushing, and the inlet ball valve should be slowly opened until the water discharged from the slurry pipe is clear and free of slurry.
After cutting off the gas source and drainage pipe, regularly remove the screws from the flange, extract the grouting cylinder, and thoroughly remove any remaining grouting material.
After cleaning, apply lubricating grease to the metal surface of the grouting cylinder and re connect and tighten it with the pump body.
It is strictly prohibited to operate the pump at high speed with no load or light load to avoid damaging various moving parts.
AfterSalesService :
Key words:- Mining pneumatic grouting pump
More Products
