BFC8115 Explosion proof Projection Light BLC8615 Explosion proof Path Light Power Plant Chemical Plant Road Light 150/200W

Description :

Applicable locations:

Widely applicable for indoor and outdoor floodlighting in flammable and explosive places such as pump rooms, equipment areas, oil stations, gas stations, and joint stations in the petroleum and chemical industries.

Structural characteristics:

Excellent explosion-proof structural design,Can be used in variousSafe use in flammable and explosive places.

LED light source, high light efficiency, long lifespan, strong shock resistance, and small size.

Reasonable light distribution design, wide illumination range, wide angle, high brightness, and uniform illumination.

Satisfy waterproof requirements in structural design, and achieve a product shell protection level ofIP65。

The outer shell of the lamp is made of special alloy material, combined with high-tech spraying technology, which has good corrosion resistance and can be reliably used in various indoor and outdoor environments.

The light source cavity and the driving cavity are designed separately, and the light source cavity is also designed separately with stepped heat dissipation fins. This not only effectively controls the temperature rise of each component, but also avoids the heat island effect (i.e. preventing local overheating), thereby prolonging the processThe service life of LED and driver.

equipU-shaped bracket can be installed in various ways such as seat type, side wall type, and ceiling type.

Installation:                                                                                                                                     

Before installing LED lights, it is necessary to check whether the basic technical data listed on the nameplate meets the actual usage conditions.

Equivalent to a diameterφ 10mm~φ 14mm cable entry line is connected to the terminal block through a rubber sealing ring, and the introduced cable is tightened with a compression nut to seal it and prevent it from being pulled out.

Before use, check if the wiring is correct and if all fastening screws (bolts) on the casing are tightened. The cable grounding wire should be reliably grounded.

During maintenance“ It is strictly prohibited to open the lid with electricity on; Do not bump or damage the rubber sealing gasket.

During maintenance, if aging is found in the sealing ring, sealing gasket, etc. of the introduced device, they should be replaced in a timely manner to ensure protective performance.

Technical Specifications 

rated voltage：AC 220V50Hz

rated power：70W/100W/150W

luminous flux：6000lm/8000lm/12000lm

power factor：zero point nine five

Average service life：100000H

Gas explosion-proof mark：Ex mbnA IIC T6/T5 Gc

Dust explosion-proof mark：Ex tD A21 IP65 T6/T5

Lamp protection level：IP65

corrosion resistance grade：WF2

insulation class：I

Exterior dimensions of lighting fixtures：550X320X77mm

Lamp Weight ：9.2Kg/9.5Kg/9.8Kg

AfterSalesService :