Drying tower hard PVC packing grid plate camel hump support Dier can customize various support parts

Description :

　　Drying tower hard PVC packing grid plate camel hump support Dier can customize various support parts

　　Packing support grid product description:

　　The packing support grid needs to be determined based on the following factors: tower diameter, tower body ellipticity, packing diameter, packing layer height, grid plate processing, manufacturing, and installation and disassembly. Due to the smaller diameter of the tower, a single block grid plate is used. When the tower diameter is less than 350mm, the grid plate can be directly welded to the tower wall. When the tower diameter is between 400-500mm, the grid plate needs to be placed on the support ring welded to the tower wall. When the diameter is large, it is advisable to use segmented grid plates. When the tower diameter is between 600-800mm, the grid plate consists of two pieces When the tower diameter is 900-1200mm, the grid plate consists of three pieces. When the tower diameter is between 1400-1600mm, the grid plate consists of four pieces. But regardless of how many pieces the grid plate is divided into, it needs to be placed on the support ring or support block welded to the tower wall. The support ring of the large tower also needs to be reinforced with support plates. Segmented grating plates, each with a width of 300-400mm. Each plate should not be too heavy to facilitate loading and unloading through the inlet holes.

　　Application of filler supported grid:

　　The packing support grid is mainly used in corrugated packing towers and bulk packing towers. In various chemical and environmental equipment, packing towers are used as packing supports. In the process of oil gas water separation in crude oil three-phase separators, corrugated plate coalesced packing is used for side and bottom support. Liusuan absorption towers, drying towers, and cooling towers add ceramic cross rings on acid resistant ceramic grid plates, and then bulk granular packing is added on top. Placing a plate of corrugated packing on the grid support is also a good method, which not only increases the opening rate of the support device, but also increases the spacing between the grid bars to over 100mm. Some of them have sawtooth grooves at the lower end of the grid Flat noodles, which can make the liquid flow down easily and evenly. The hard PVC filler grid produced below has a diameter of DN2700, a height of 100mm, and a plate thickness of 16MM as requested by the customer. The quantity includes 2 sets of filler grids and 2 sets of pressure grids.

　　Our company is a large-scale chemical packed tower internals enterprise in the domestic industry that integrates design and research and development, production equipment automation, installation and after-sales service, and technical guidance standardization (with 17 years of experience). It is a key supported industry for development, and its products are widely used in industries such as environmental protection, fine chemicals, petrochemicals, refining, coking, light industry metallurgy, steel plants, etc; The registered capital is 98 million yuan, fixed assets are 50 million yuan, and there are approximately 286 employees, including 26 technical personnel. We produce more than 100 products including environmental protection device fillers, ship smoke control fillers, plastic fillers, metal and ceramic fillers, tower internals, chemical equipment, etc. Especially in recent years, the business of environmental protection tower installations has been continuous, and the environmental protection tower installations that have been jointly designed and produced by our company, Hebei University of Technology, East China University of Science and Technology, Tianjin University, and Tsinghua University have been running well.

AfterSalesService :

• Packing grid plate